37.23 · Technische Änderungen vorbehalten · Technical amendments reserved · Modifications techniques réservées
!
Lichtbauelementrohr
Light building element tube
Tube de profilé lumineux
Gebrauchsanweisung
Anwendung
Lichtbauelementrohr ø 220 mm aus Aluminium
mit Erdstück.
Mit einstellbarem Scheinwerfer für die
Anstrahlung architektonischer Details im
unmittelbaren Umfeld des Lichtbauelements.
Für die Verwendung in Kombination mit einem
Lichtbauelementkopf.
Produkteigenschaften
Widerstand gegen horizontale Lasten:
v
= 32 m/s
ref,0
Geländekategorie: 1
nach DIN EN 1991-1-4
Leuchten mit einem Gewicht bis 60 kg
und einer Windangriffsfläche max. 0,3 m²
Verformungsklasse: 1 – Sicherheitsklasse: A
in Anlehnung an DIN EN 40-3-3
Verhalten bei Fahrzeuganprall nach
DIN EN 12767 (passive Sicherheit): Klasse 0
Bodenbeschaffenheit
Das Lichtbauelement darf nicht dauerhaft mit
aggressiven Medien in Kontakt kommen.
Aggressive Medien können durch Wasser
aus dem Boden gewaschen werden, und das
Lichtbauelement zerstören.
Bei unbekannter Zusammensetzung des
Bodens ist daher vor der Montage eine
Bodenanalyse vorzunehmen.
Aggressive Medien können auch von der
Oberfläche ausgehend auf das Lichtbauelement
einwirken, daher ist ein übermäßiger Einsatz
von Taumitteln im Umfeld zu vermeiden.
Von außen eintretende Streuströme können
Korrosionsschäden verursachen. Es sind
geeignete Gegenmaßnahmen durchzuführen.
Ø 220
Ø 220
Instructions for use
Application
Aluminium light building element tube
ø 220 mm with anchorage unit.
With adjustable floodlight for the illumination of
architectural details in the immediate vicinity of
the light building element.
For use in combination with a light building
element head.
Product characteristics
Resistance against horizontal loads
v
= 32 m/s
ref,0
Terrain category: 1
in accordance with DIN EN 1991-1-4
Luminaires with a maximum weight of 60 kg
for a wind catching area max. 0.3 m²
Deformation class: 1 – Safety class: A
based on DIN EN 40-3-3
Properties in case of vehicle impact
(passive safety): class 0 in accordance with
DIN EN 12767
Soil conditions
The light building element must not have
sustained contact with aggressive media.
Aggressive media may be washed out of the
ground and may corrode the light building
element.
If the composition of the ground is unknown,
a ground analysis should be performed before
installation.
Aggressive media from the surface may also
affect the light building element. The overuse
of de-icing agents in the surroundings should
therefore be avoided. Stray currents entering
from outside may cause corrosion damage.
Suitable countermeasures should be put in
place.
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info @ bega.com · www.bega.com
8×8
Fiche d'utilisation
Application
Tube de profilé lumineux ø 220 mm en
aluminium avec partie à enterrer.
Avec projecteur réglable pour l'illumination
de détails architecturaux situés à proximité
immédiate du profilé lumineux.
Pour une utilisation en association avec une
tête de profilé lumineux.
Caractéristiques du produit
Résistance aux charges horizontales :
v
= 32 m/s
ref,0
Catégorie de terrain : 1
selon la norme DIN EN 1991-1-4
Luminaires d'un poids allant jusqu'à 60 kg
et une surface de prise au vent de 0,3 m² max.
Classe de déformation : 1 – Classe de
sécurité :A d'après la norme DIN EN 40-3-3
Comportement en cas de choc avec un
véhicule selon la norme DIN EN 12767
(sécurité passive) : classe 0
Nature du sol
Le profilé lumineux ne doit pas être
durablement en contact avec des matériaux
corrosifs.
L'eau peut entraîner les matériaux corrosifs du
sol et endommager le profilé.
Si la composition du sol n'est pas connue, il
est nécessaire d'en faire une analyse avant
l'installation de l'appareil.
Certains matériaux corrosifs pouvant également
attaquer le profilé depuis la surface, il convient
de limiter l'utilisation de produits de salage aux
abords de l'appareil. Des courants vagabonds
venant de l'extérieur peuvent provoquer de la
corrosion. De ce fait, les mesures de prévention
appropriées doivent être prises.
84 722
r
é
c
IP 65
1 / 4
Need help?
Do you have a question about the 84722K3 and is the answer not in the manual?
Questions and answers