Guidance Screen; Dyn. Route Sett - VDO MS 3200 Owner's Manual

SYSTEM SETTINGS

Guidance screen

Here you can select the information which should appear on the guidance screen.
Show event
Select whether traffic obstructions on your route should appear in the top line of
the guidance screen or not.
Remain. distance
Select whether the distance-to-go to the destination or via point should appear in
the status field of the guidance screen or not.
Times
Select which times should appear in the status field of the guidance screen. The
following options are available:
–
Time of arrival
–
Remaining time
–
Current time
–
No time display

Dyn. route sett.

Settings for dynamic route planning
Re-route lev.
Use this setting to specify whether the navigation system should plan a detour in the
event of traffic obstructions or not. Five levels are available. The lowest level (1) means
that the direct route should go through the stationary traffic depending on the
conditions and the anticipated delay. If the highest level is selected, an alternative
route should be planned in most cases.
Level 3 is a standard setting for dynamic route planning. It is the factory setting
(default).
Horizon
This setting determines the radius in which the navigation system should take traffic
obstructions into account when planning your route. Select a value between 25 and
150 km.
Delay
Use this value to indicate the anticipated delay time due to a traffic obstruction at or
above which the navigation system should suggest that a new route be planned.
Select a value between 5 and 60 minutes.
The anticipated delay is calculated on the basis of the data received from the TMC
station and may deviate from the actual situation.
50