D R I V E C O N T R O L L E R F A I L U R E
CD
commands from the computer (see "Drive Problems" on page 109).
The hard drive cannot read the data (see "Drive Problems" on
A T A E R R O R
D
—
page 109).
E C R E A S I N G A V A I L A B L E M E M O R Y
D
faulty or improperly seated. Reinstall the memory modules and, if necessary,
replace them (see "Memory" on page 150).
I S K
F A I L E D I N I T I A L I Z A T I O N
D
C :
hard drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 101).
R I V E N O T R E A D Y
D
can continue. Install a hard drive in the hard drive bay (see "Hard Drive" on
page 143).
R R O R R E A D I N G
E
P C M C I A
ExpressCard. Reinsert the card or try another card (see "Using ExpressCards"
on page 79).
X T E N D E D M E M O R Y S I Z E H A S C H A N G E D
E
NVRAM does not match the memory installed in the computer. Restart the
computer. If the error appears again, contact Dell (see "Contacting Dell" on
page 179).
H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
T
that you are trying to copy is too large to fit on the disk, or the disk is full. Try
copying the file to a different disk or use a larger capacity disk.
F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
A
Do not use these characters in filenames.
> | —
A T E
F A I L U R E
G
A 2 0
modules and, if necessary, replace them (see "Memory" on page 150).
E N E R A L F A I L U R E
G
command. The message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action.
A R D
D I S K D R I V E C O N F I G U R A T I O N E R R O R
H
-
drive type. Shut down the computer, remove the hard drive (see "Hard Drive"
on page 143), and boot the computer from a CD. Then, shut down the
computer, reinstall the hard drive, and restart the computer. Run the Hard
Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 101).
The CD drive does not respond to
—
—
The hard drive failed initialization. Run the
—
The operation requires a hard drive in the bay before it
—
C A R D
—
A memory module may be loose. Reinstall the memory
—
The operating system is unable to carry out the
—
One or more memory modules may be
The computer cannot identify the
The amount of memory recorded in
—
The computer cannot identify the
—
The file
—
: \ / : * ? " <
Troubleshooting
113