Altec Lansing Moondance Glow M402SR User Manual page 24

Troubleshooting
Symptom
iPod didn't charge
Sound is distorted
Enhanced remote doesn't
work
No sound from the AUX
device, such as an MP3
player or CD player
connected to the AUX jack
22
Possible Problem
iPod is not installed properly
iPod is locked up
AC adapter isn't plugged into a wall outlet,
or the connector is not plugged into the
power supply jack on the back of the
speaker system
Volume level is set too high
Sound source is distorted
Battery is weak
Enhanced remote is not pointed toward
the speaker system
Volume on the device is set too low
Source selector is not set to AUX
Solution
Remove your iPod from the dock and check for obstructions on the
connectors in the dock and on your iPod. Then reseat it in the dock.
Please make sure your iPod is working properly before docking into the unit.
Please refer to your iPod manual for details.
Plug the AC adapter into a wall outlet and plug the connector into the supply
jack on the speaker system.
Decrease the volume.
If the iPod original sound source (MP3) is of poor quality, distortion and noise
are easily noticed with high-power speakers. Try a different audio source such
as a music CD.
Replace current battery with a new battery.
Point the enhanced remote toward the Altec Lansing speaker system and
move within 10 feet of the unit.
Increase the volume on the device to approximately ¾ full volume.
Set source selector to AUX.