How To Install The Base - Beko Bd 610 User Manual

Q Handset Locator Button
Press this to make the handset ring, if
you cannot remember where you put
rt, press it again to stop the handset
ringing.
El
Network Light
The Network light comes on when you
have a connection to the Ethernet.
[3 In Use Light
The IN USE light comes on when you
place calls.
[Q Charge Light
The CHARGE light comes on when
the handset's batteries are being
charged.
Note: Before you can use the handset to make calls for the first time, you will need
to fit and fully charge the batteries for 15 hours.
How To Install The Base_
1. Connect A on the base to a LAN
(Local Area Network) port on your
broadband connection (modem, router,
hub, switch etc.) using the provided
Ethernet cable.
2. Connect the power adapter to an
active power outlet and connect the
power port on the base to the power
adapter (9V, 500 mA).
3. Connect S on the base to a telephone
socket (if available) using the provided
telephone cable.
1. Push the top of the battery
compartment cover on the back of the
handset downwards.
2. Insert the two batteries provided with
the handset making sure that their plus
and minus ends are facing the same
way as shown in the illustrations on the
sides of the battery compartment.
3. Slide the battery compartment cover
shut.
How to Install the Handset