Dell Inspiron 8600 Owner's Manual page 137

Performing a One-Time Boot
You can set a one-time-only boot sequence without entering the system setup program.
(You can also use this procedure to boot the Dell Diagnostics on the diagnostics utility
partition on your hard drive.)
Turn off the computer.
1
If the computer is connected to a docking device (docked), undock it. See the
2
documentation that came with your docking device for instructions.
Connect the computer to an electrical outlet.
3
Turn on the computer. When the DELL logo appears, press
4
wait too long and the Windows logo appears, continue to wait until you see the
Windows desktop. Then shut down your computer and try again.
When the boot device list appears, highlight the device from which you want to boot
5
and press
The computer boots to the selected device.
The next time you reboot the computer, the previous boot order is restored.
Changing Printer Modes
Set the Parallel Mode option according to the type of printer or device connected to the
parallel connector. To determine the correct mode to use, see the documentation that came
with the device.
Setting Parallel Mode to Disabled disables the parallel port and the port's LPT address,
freeing computer resources for another device to use.
Changing COM Ports
Serial Port allows you to map the serial port COM address or disable the serial port and its
address, freeing computer resources for another device to use.
Enabling the Infrared Sensor
Enter the system setup program:
1
Turn on your computer.
a
Press when the DELL™ logo appears.
b
Press
2
Configuration.
.
until you locate Infrared Data Port under Basic Device
immediately. If you
Appendix
137