Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Lippert Manuals
  4. Boating Equipment
  5. SURESHADE 3000 Series
  6. Owner's manual

Lippert SURESHADE 3000 Series Owner's Manual

Arch power bimini
Hide thumbs Also See for SURESHADE 3000 Series:

Advertisement

Quick Links

Download this manual
3000 Series Arch
Power Bimini
OWNER'S MANUAL
Scan for product support

Advertisement

loading
Need help?

Need help?

Do you have a question about the SURESHADE 3000 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lippert SURESHADE 3000 Series

Summary of Contents for Lippert SURESHADE 3000 Series

  • Page 1 3000 Series Arch Power Bimini OWNER'S MANUAL Scan for product support...
  • Page 2 Manual Override Wiring Diagram Notes Introduction The SureShade 3000 Series Arch Power Bimini is an electric actuator-driven Bimini top powered by a 12V DC source, controlled by a helm-mounted momentary switch. Additional information about this product can be obtained from lci1.com/support or by downloading the free LippertNOW app.
  • Page 3 Failure to correctly follow the provided instructions may result in death, serious personal injury, severe product and/or property damage, including voiding of the Lippert limited warranty. The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause death or serious personal injury if not performed safely and within the parameters set forth in this manual.
  • Page 4 Although opening (extending) and closing (retracting) of the power bimini can be stopped in any position, Lippert recommends only fully opening or closing the bimini top to ensure proper and safe operation and to prevent any possible damage from external influences.
  • Page 5 Bimini top will not Repair or replace as necessary. Refer to Wiring close. Diagrams. Damaged Perform manual override. Contact Lippert. actuator. Foreign material Remove foreign material from gear handle. Inspect gear blocking gear handle and actuator for damage. Perform manual override if handle.
  • Page 6 Maintenance Actuator • Rinse with fresh water, especially in salt water environments. • Periodically check for loose mounting. Tighten mounting hardware as necessary. Fabric Care Use clear water to consistently hose off the bimini top fabric during the boating season. If necessary, do a deeper clean of the bimini top fabric as follows: Unzip the protective boot and fully open the bimini top (Fig.
  • Page 7 Manual Override If the arch power bimini will not retract into the closed position, a manual override of the top must be done before putting the boat underway. Perform a manual override of the arch power bimini as follows: Remove the front end cap of either the starboard or port actuator. Retrieve the provided 5/32"...
  • Page 8 Wiring Diagram The 5 Amp auto-reset circuit breaker used on the 3000 Series Arch Power Bimini MUST be protected by a 15 Amp auto-reset circuit breaker or a 30 Amp fuse. The 5 Amp auto-reset circuit breaker provides protection for the Power Bimini System and NOT for the entire craft’s electrical wiring system.
  • Page 9 Notes Page 9 Rev: 10.31.24 CCD-0008994...
  • Page 10 Lippert representative has been provided.  Any unauthorized use shall void any applicable warranty.  The information contained in this manual is subject to change without notice and at the sole discretion of Lippert.  Revised editions are available for free download from lippert.com.