CTS CVT-5102SFP-MG User Manual

Trademarks
CTS is a registered trademark of Connection Technology
Systems Inc. Contents subject to revision without prior
notice.
All other trademarks remain the property of their owners.
Copyright Statement
Copyright  Connection Technology Systems Inc.
This publication may not be reproduced as a whole or in
part, in any way whatsoever unless prior consent has been
obtained from Connection Technology Systems Inc.
FCC Warning
The CVT-5102SFP-MG media converter has been tested
and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These
standards are designed to provide reasonable protection
against harmful interference when these devices are
operated in a commercial environment. These devices
generate, use, and can radiate radio frequency energy and
may cause harmful interference to radio communications
unless installed in accordance with this User's Guide.
Operation of these devices in a residential area is likely to
cause harmful interference which will make the user
responsible for the appropriate remedial action at his / her
own expense.
CE Mark Warning
These are Class A products. In a domestic environment
these products may cause radio interference in which case
the user will need to consider adequate preventative
methods.
1. Overview
Thank you for purchasing CTS CVT-5102SFP-MG
Managed Media Converter. In this user's guide, "Media
Converter" will be used as an alternative name for the
CVT-5102SFP-MG.
Major Features:
- TP Auto-Negotiation
- MDI/MDIX Auto-Crossover
- 16K Bytes Jumbo Frame
- Store and Forward switching mechanism
- 4K MAC address
- Flow Control *
- IP Management via CLI, WEB, SNMP interfaces
- VLAN, QoS, DHCP snooping
- iProbe Advanced Diagnostics
* Automatically enabled when the F/O port operates at 10G, and
the copper port operates at 5G, 2.5G, 1G or 100M.
2. Checklist
The items listed below should be included in the package:
- Media Converter
- AC-DC Power Adapter
- Quick Guide
Please contact your sales representative for assistance
immediately if any item is missing or damaged.
3. Installation
 Insert the SFP/SFP+ transceiver into the SFP/SFP+
slot.
 Attach fiber cable from the media converter to the fiber
network. The fiber connector must be matched –
transmit socket to receive socket.
 Attach a UTP cable from the 10G/5G/2.5G/1G/100M
BASE-T network to the RJ-45 port on the media
converter.
 Connect the power source to the media converter and
check that the Power LED lights up. The TP
Link/Act/Speed and F/O Link/Act/Speed LEDs will light
up when all the cables are properly connected.
 Perform a reset or restart (if needed):
1. Press the reset button for more than 5 seconds until
the STA LED lights up in orange, then release it.
The system will restart.
2. Press the reset button for more than 10 seconds
until the STA LED blinks in orange, then release it.
The system will restart with default settings.
Figure 1. Front Panel of Media converter
Figure 2. Rear Panel of Media converter