System Memory - Dell POWEREDGE 4300 Service Manual

A-4 Dell PowerEdge 4300 Systems Service Manual
Serial Port 1
Serial Port 2
Parallel Port
Parallel Mode
Diskette
Speaker
Primary SCSI
Secondary SCSI
Processor field
Level 2 Cache

System Memory

Video Memory
Service Tag
Asset Tag
Configures system's built-in serial ports. These
options may be set to Auto (default) to
automatically configure a port, to a specific
designation (COM1 [3F8h] or COM3 [3E8h] for
Serial Port 1; COM2 [2F8h] or COM4 [2E8h]
for Serial Port 2), or to Off.
Configures system's built-in parallel port. The
port's I/O address may be set to 378h
(default), 278h, 3BCh, or to Off to disable the
port.
Controls whether system's built-in parallel port
acts as an AT-compatible (unidirectional) or
PS/2-compatible (bidirectional) port.
Controls operation of the system's built-in dis-
kette controller.
Determines whether the built-in speaker is On
(default) or Off.
Turns the respective SCSI controllers on or off.
Selecting On (default) enables a controller and
allows scanning of the devices connected to it,
allowing the device with the lowest SCSI ID to
function as a boot device (unless a boot device
connected to an enabled controller higher in
the scan sequence has already been
detected). Selecting Off causes the BIOS to
mask the presence of a controller.
Displays microprocessor type and speed.
Displays size of integrated cache.
Displays entire amount of installed memory
detected in system, except for memory on
EMS expansion cards.
Displays amount of video memory detected.
Displays system's five-character service tag
number.
Displays the asset tag number if one is
assigned.