Section 14. Audio; Overview / Description; Section 15. Rack Information; Cable Management Arm (Cma) - Dell POWEREDGE R710 Series Technical Manualbook

Dell™ PowerEdge™ R710 Technical Guidebook

sectiOn 14. auDiO

a. Overview / Description
No speakers supported

sectiOn 15. Rack infORmatiOn

a. Overview / Description
Rack installation components such as rails are provided with the PowerEdge R710 Rack Kit. The rack
installation components are as follows: Sliding Rack mount with latest generation Cable Management
Arm (CMA). When the system is installed in a rack, please observe the following guidelines:
Nothing should be located within 12" of the front of the unit that would restrict the airflow into the system.
Nothing should be mounted or placed behind the chassis that would restrict airflow from exiting the
system. Only Dell approved CMAs can be placed behind the chassis. All other objects should be located
at least 24" away from the rear of the chassis.
When two systems are placed back to back, the separation between the units should be at least 24" if
the exit airflow is equivalent for the two chassis. This allows the exit air to escape without creating an
extreme back pressure at the rear of one of the chassis.
b. cable management arm (cma)
cable tyPe
Mouse – USB
Keyboard – USB
Video – VGA
Power Cords
LOMs – Ethernet
PCI NICs
Total
Notes: • C MA supports for the maximum number of cables supported by system
• T he numbers in this matrix represent the number and types of external cables required to be
supported by the CMA solution.
• T his matrix is built on the practical worst case configuration in each platform based on prior
and projected take rates. Note that other combinations of adapters and associated cables exist,
but are assumed to fall within these guidelines from the standpoint of bend radius and
flexibility, cable bundling, cable volume, etc.
• P CI NIC cables are assumed to be Ethernet.
• K VM cable dongle may be used for mouse/keyboard/video.
numbeR Of cables
1
1
1
2
1
1
8
43