AVS Aeroskin, Aeroskin II Manual

Contents

NOTE: Actual product may vary from illustration.

Tools Required

Preparation Before Painting / Installation

• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.

Installation Steps

NOTE: Actual application may vary slightly from illustrations.

1. Prior to installation, wash the hood of vehicle and dry with a clean cloth.
   
   
2. Lay Aeroskin in place on vehicle and mask off the surrounding areas with tape.
   
   
3. Use alcohol pads to clean the entire LEADING EDGE of the hood. Let dry.
   
   
4. Apply surface prep to painted surface where Aeroskin will attach. Let dry.
   
   
5. Remove and discard masking tape.
   
   
6. Expose 2" (5 cm) of tape liner from each section of Aeroskin. Ensure you can access the free ends of tape liner. NOTE: Inspect part thoroughly to confirm all sections of tape liner are exposed.
   
   NOTE: Some applications do not have side tape by design.
7. Center the Aeroskin on the hood.
   
   NOTE: Actual application may vary slightly from illustrations.
8. Begin removing remaining tape liner, beginning with the drivers side CENTER TOP. Grasping the free end, pull tape gently in 6" (15 cm) sections, while applying even pressure with hand to Aeroskin. Repeat process for passenger side.
   
   
   You must apply even pressure from center section out to each end of part, in order for proper adhesion to hood.
   NOTE: Do not apply pressure closer than 6" (15 cm) to tape liner as it could accidentally break.
9. Using the same process, remove tape liner from the driver side CENTER BOTTOM of hood skin. Repeat for passenger side.
   
   
   You must apply even pressure from center section out to each end of part, in order for proper adhesion to hood.
10. Again using the same process, remove tape liner from the driver side FAR SIDE EDGE of Aeroskin. Repeat for passenger side.
    
    NOTE: Some applications do not have side tape by design.
11. Again using the same process, remove tape liner from the driver side FAR BOTTOM EDGE of hood skin. Repeat for passenger side.
    
12. Press firmly along all edges of Aeroskin to ensure adhesion of tape to hood surface.
    

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.

Important Safety Information

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.

• 
  Before driving, ensure that the Aeroskin is properly secured to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download AVS Aeroskin, Aeroskin II Manual