Troubleshooting for Anynet
¦
Problem
Anynet
does not work.
+
I want to start Anynet
.
+
I want to exit Anynet
+
.
The message "Connecting to
Anynet
device..." appears on the
+
screen.
The Anynet
device does not play.
+
The connected device is not
displayed.
The TV programme cannot be
recorded.
The TV sound is not output
through the receiver.
+
Possible Solution
•
Check if the device is an Anynet
•
Connect only one receiver (home theatre).
•
Check if the Anynet
device power cord is properly connected.
+
•
Check the Anynet
device's Video/Audio/HDMI Cable connections.
+
•
Check whether
Anynet
(HDMI-CEC) is set to On in the Anynet
+
•
Check whether the TV remote control is in TV mode.
•
Check whether it is Anynet
exclusive remote control.
+
•
Anynet
doesn't work in certain situations. (Searching channels, operating Media Play or Plug & Play
+
(Initial setup), etc.)
•
When connecting or removing the HDMI cable, please make sure to search devices again or turn your TV off
and on again.
•
Check if the Anynet
Function of Anynet
+
•
Check if the Anynet
device is properly connected to the TV and check if the Anynet
+
On in the Anynet
Setup menu.
+
•
Press the
TOOLS
button to display the Anynet
•
Select
View TV in the Anynet
+
•
Press the
SOURCE
button on the TV remote control and select a device other than Anynet
•
Press
P
>/<, PRE-CH, and
when a tuner-embedded Anynet
•
You cannot use the remote control when you are configuring Anynet
•
Use the remote control when the Anynet
•
You cannot use the play function when
•
Check whether or not the device supports Anynet
•
Check whether or not the HDMI Cable is properly connected.
•
Check whether
Anynet
(HDMI-CEC) is set to On in the Anynet
+
•
Search Anynet
devices again.
+
•
You can connect an Anynet
device using the HDMI Cable only. Some HDMI cables may not support Anynet
+
functions.
•
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord or a power
failure, please repeat the device scan.
•
Check whether the antenna jack on the recording device is properly connected.
•
Connect the optical cable between TV and the receiver.
device. The Anynet
system supports Anynet
+
+
setup menu.
+
device is set on.
+
menu and select a menu you want.
+
menu.
FAV.CH
to change the TV mode. (Note that the channel button operates only
+
device is not connected.)
setting or switching to view mode is complete.
+
Plug & Play (Initial setup) is in progress.
functions.
+
setup menu.
+
devices only.
+
(HDMI-CEC) is set to
+
+
devices.
or switching to a view mode.
+
English
+
31