Cable Connections For Watching Digital And/Or Conventional Tv Channels; Connecting Vhf/Uhf Antennas And A Cable Converter; Cable Connections For Watching Digital Tv Channels Over Air (Vhf/Uhf) - Pioneer PDP-4345HD Operating Instructions Manual

Plasma display system, plasma display & media receiver
Table of Contents

Advertisement

Available languages

Available languages

Preparation
Cable connections for watching digital
and/or conventional TV channels
This system is equipped with two terminals for inputting TV
broadcasting signals: ANTENNA/CABLE A IN and ANTENNA B.
The ANTENNA/CABLE A IN terminal accepts both digital and
conventional TV broadcasting signals while the ANTENNA B
terminal accepts only conventional TV broadcasting signals.
When using a cable TV to watch digital and/or conventional TV
channels, connect to the ANTENNA/CABLE A IN terminal as
shown. In addition, you may connect an antenna to the
ANTENNA B terminal as shown; use an outdoor antenna to
enjoy clearer pictures. If your outdoor uses a 75-ohm coaxial
cable with an F-type connector, plug it into the antenna
terminal at the rear of the Media Receiver.
Connecting VHF/UHF antennas and a Cable
Converter
Media Receiver (rear)
Splitter
Cable TV
Cable Converter
ANTENNA B
Media Receiver (rear)
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
ANTENNA/
CABLE A IN
IN
OUT
Cable connections for watching digital
TV channels over air (VHF/UHF)
If using VHF and UHF antennas to watch digital TV channels,
connect the coaxial cables as shown.
Connecting VHF/UHF antennas
VHF antenna
U/V mixer
ANTENNA B
IN
Media Receiver
(rear)
OUT
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
UHF antenna
Splitter
ANTENNA/
CABLE A IN
06
21
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents