Set A Switch Point On Routes For 2 Mixing And Feeding Robots; Download A Route To The Feed Controller Software - LELY VECTOR Operator's Manual

5.7.6

Set a Switch Point on Routes for 2 Mixing and Feeding Robots

5.7.7

Download a Route to the Feed Controller Software

Operating Instructions
4 Switch Feed
point loading
point
5
Parking Feed
position loading
point
6 - Feed Switch
16 loading point
point
For a Vector system with 2 Mixing and Feeding Robot only the routes to
the locations with animals must be activated. The other route numbers
1, 3, 4 and 5 must be set "Off".
On route number 2, 6 -16 a switch point must be set:
1. Connect the smartphone (see page 5-8) to the Feed Controller.
2. Go to the page Settings > Routes Frobot > Zone changepoint.
3. Select the route (2, 6 -16),
A list of route actions is shown.
4. Select the route action that is located on the switch point.
5. Push
"SET",
two xx appear in front of the route action.
6. Push to save the set switch point.
A question appears: "Save changepoint zone?".
7. Push button "Yes", to save the switch point.
When a new route was programmed on the Mixing and Feeding Robot,
the route will be automatically downloaded on the Feed Controller
when the Mixing and Feeding Robot is near the power distribution box.
Do this procedure only when downloading is not automatically done.
1. Make sure the Mixing and Feeding Robot is within reach of the blue
tooth signal of the power distribution box.
2. Make sure you know the route number that must be downloaded.
3. Connect the smartphone (see page 5-8) to the Feed Controller.
4. Go to the page Settings > Routes Frobot > Download route.
5. Select the route number you want to download and push
6. A question appears: "Download from Frobot? Overwrite route in FC!"
Select:
Load the MFR when other MFR is off
line and connected to the secondary
charger
Load the MFR when other MFR is
feeding or scanning
To locations with animals on the fence
.
5-29