Panasonic Toughbook CF-18BCAGCMM Reference Manual page 19

Digitizer (Advanced)
Functions
Right-clicking
CAUTION
When the internal LCD is used alone or with an external display simultaneously, the
digitizer function cannot be used when the area of either display is set larger than
default setting of the display resolution.
Even when only an external display is in use, the cursor will move on the external
display if you touch the surface of the internal LCD with the pen or bring the pen close
to the surface of the internal LCD when the digitizer driver is active. Therefore, do not
touch the internal LCD when only an external display is in use.
If a change is made to the display resolution, or the cursor can not be pointed
correctly with the pen, be sure to perform [Calibration]. (
The digitizer function can not be used in the Setup Utility or when using the full screen
in [Command Prompt].
NOTE
You can move the cursor by bringing the pen close to the screen, without actually
touching the screen's surface.
For information on how to use the pen (included), refer to [Get Going with Tablet PC]
in [start] - [All Programs].
Do not move the pen too quickly. If the pen moves too quickly, the cursor may be
unable to follow its movement.
If you cannot click on the edge of the screen, hold the pen perpendicular to the display
and try clicking again.
19
Operation
Press and hold down the pen button (A),
then tap the object.
page 20)