Panasonic Viera TH-37PH10 Operating Instructions Manual page 15

Standby (ON / OFF) button
The Plasma Display must fi rst be plugged into the wall outlet and turned on at the power switch (see page 13).
Press ON to turn the Plasma Display On, from Standby mode. Press OFF to turn the Plasma Display Off
to Standby mode.
POSITION buttons
ACTION button
Press to make
selections.
SOUND button
(see page 25)
R button (see page 17)
Press the R button to return to previous menu screen.
Status button
Press the "Status" button to display the current system status.
PC
NORMAL
OFF TIMER 90
SET UP button (see page 16, 17)
DIRECT INPUT buttons
Press the INPUT "1", "2", "3" or "PC" input mode selection button to
select the INPUT mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed. If you press the button
whose slot is not installed, it automatically displays the current input signal.
Notes:
• For TH-37PH10UK, press
INPUT1A and INPUT1B. The input mode is not switched to INPUT3
even if pressing .
• For TH-42PH10UK, TH-50PH10UK and TH-58PH10UK, press
switch the input mode between INPUT2A and INPUT2B.
• Image retention (image lag) may occur on the plasma display panel when
a still picture is kept on the panel for an extended period. The function that
darkens the screen slightly is activated to prevent image retention (see
page 46), this function is not the perfect solution to image retention.
Channel Adjustment
This button cannot be used for this model.
Volume Adjustment
Press the Volume Up "+" or Down "–" button to increase or decrease
the sound volume level.
OFF TIMER button
The Plasma Display can be preset to switch to stand-by after a fi xed
period. The setting changes to 30 minutes, 60 minutes, 90 minutes and
0 minutes (off timer cancelled) each time the button is pressed.
30
When three minutes remain, "OFF TIMER 3" will fl ash.
The off timer is cancelled if a power interruption occurs.
Remote ID lock (see page 35)
Digital Zoom (see page 26)
Press to access
Digital Zoom.
This displays an enlargement of the designated part of the displayed image.
Basic Controls
1
Input label
1
2
Aspect mode (see page 19)
2
Off timer
3
The off timer indicator is
displayed only when the off
3
timer has been set.
to switch the input mode between
60 90
0
to
15