Usb Device - Logicube WriteProtect PORTABLE User Manual

5.3.4 USB Device

This section allows advanced configuration for the WriteProtect.
EXPORT MODE – Changes the behavior on how the computer's Operating
System will interact with the connected drive.
•
•
EXPORT TYPE – This setting changes the behavior on how the computer's
Operating System will see the connected drive.
•
•
•
DCO PASSTHROUGH – Changes to DCO is persistent and may be permanent.
Always proceed with caution when changing the DCO. By default, this is set to
DISABLED, disallowing changes to the DCO. If changes need to be performed to
the DCO, set this to ENABLED.
WriteProtect PORTABLE
Logicube
WRITE SUPPRESS – Will make it so that it looks like changes can be
made, but no changes will occur. On rare occasions, this setting may
need to be used for drives that are not properly detected (for example,
Windows may show a notice that the connected drive needs to be
formatted).
READ ONLY (Default) – Sets the drive in a Read-Only state. Attempts to
alter the contents of the drive will result in error messages or notices
that the drive is Read-Only.
FIXED DRIVE – Will make it so that the connected computer's Operating
System sees the connected drive as a fixed drive (non-removable).
REMOVABLE – The connected computer's Operating System will see the
connected drive as a removable disk.
AUTO (Default) – The WriteProtect will automatically choose based on
the type of drive connected.
User's Manual
21
WEB INTERFACE