NEC MultiSync LCD2490WUXi User Manual page 24

Advanced OSM Controls
Tag 7 SHARPNESS
DVI SELECTION
HDCP CONTENT
(Digital Input Only)
VIDEO DETECT
OFF TIMER
IPM
(Intelligent Power
Manager)
IPM SETTING
OVER DRIVE
This function is digitally capable of keeping an image crisp at any
resolution at any time. This setting can be set independently for
different signal timings (resolution settings).
This function selects the DVI input mode. If the DVI selection
changes, you must restart your computer.
AUTO: When using the DVI-D to DVI-D cable, the DVI SELECTION
is DIGITAL.
When using the D-SUB to DVI-A cable, the DVI SELECTION
is ANALOG.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
Selects the type of input to be used with HDCP CONTENT.
OFF: When a PC or other computer is connected, select "OFF".
ON: When a DVD player or other type of high definition device is
connnected, select "ON".
Note: Interlaced signals (480i, 576i, 1080i) are not supported. If
you have any problems, please refer to the Troubleshooting section
of this User's Manual.
Selects the method of video detection when more than one video
input is connected.
FIRST: If "FIRST" is selected as the VIDEO DETECT option, the moni-
tor displays the signal from the first input port. If there is no signal
present at the first input port, then the monitor will search for a
signal from the next input port.
If a new input signal is connected to another of the monitor's input
ports while the monitor is in FIRST mode, the monitor will not switch
automatically to the new source.
LAST: If "LAST" is selected as the VIDEO DETECT option, then each
time a new input source is detected, the monitor automatically
displays the new signal.
NONE: The monitor will only search other input ports while the
power is on.
Monitor will automatically power off after a user-determined length
of time passes. Before powering off, a message will appear on the
screen asking the user if they want to delay the turn off time by 60
minutes. Press any OSM button to delay the turn off time.
The Intelligent Power Manager allows the monitor to enter into a
power saving mode after a period of inactivity. The IPM has three
settings.
OFF: Monitor does not go into power save mode when the input
signal is lost.
STANDARD: Monitor enters power save mode automatically when
the input signal is lost.
OPTION: Monitor enters power save mode automatically when the
amount of surrounding light goes below the level that is determined
by the user.
Adjusts the luminance value for IPM.
Turns the OVER DRIVE function ON or OFF. Over Drive may reduce
blurring that occurs in some moving images. When Over Drive is
on, response time is improved.
21
– continued