Remote Control Numbering Function - Mitsubishi Electric LDT421V User Manual

42" lcd display monitor
Hide thumbs Also See for LDT421V:
Table of Contents

Advertisement

NOTE 3: "PIP" and "POP"
The following table shows the combination of signal inputs under which the "PIP" and "POP" modes function. These modes
do not function, however, when the screen size is "CUSTOM" or "REAL".
RGB1
RGB1
RGB2
RGB3
DVD/HD
VIDEO<S>
VIDEO
Press the "PIP ON/OFF" buttons on the remote control to change between "PIP" and "POP" mode
as shown in the diagram below.
PIP
A
B
"PIP", "POP" mode resolution (Reference)
PIP SIZE
POP SIZE
< Remote control numbering function >
By connecting multiple LDT421V monitors using RS-232C cables, you can control any one monitor or all the monitors by one
remote controller.
1. Assign arbitrary ID number to each of multi-connected LDT421V monitors using MONITOR ID.
ID numbers 1 to 26 are selectable.
It is recommended to assign sequential ID numbers from 1 and up.
2. The remote control mode of the fi rst LDT421V monitor is set to PRIMARY and those of the other monitors are set to
SECONDARY.
3. When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY
button on the remote controller, the ID selection OSD appears at the upper left of the screen.
ID:1
ID No. :2
4. Direct the remote controller at the remote control signal sensor of the PRIMARY monitor.
OSD appears on the monitor having the ID number you selected.
NOTE:
When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller
again to cancel the ID selection OSD and then control the monitor you selected.
HINT:
If you set the remote control mode wrongly and remote control operation becomes unavailable, press any button on the control
panel of the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing
and holding down the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to
NORMAL.
SUB
RGB2
RGB3
DVD/HD
POP
A
B
: 320 dots X 240 dots
SMALL
MIDDLE
: 480 dots X 320 dots
LARGE
: 640 dots X 480 dots
: 320 dots X 240 dots
ID number of the currently viewed monitor
Select the ID number of the monitor you want to control using the +/- button
on the remote controller.
The ID of the monitor you want to control is displayed at the upper left of its screen.
By selecting ALL, you can control all the multi-connected monitors.
English-31
VIDEO<S>
VIDEO
OFF
A
: Supported
: Not supported

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ldt421v2Lr617

Table of Contents