Laney LC50-112 Operating Instructions Manual page 13

be used to control another L 5 -112 amplifier connected to this socket via its own return socket. Some Effects are better
suited to being between the guitar and amplifer input - these are foot pedal types / distortion / wah wah pedals etc. Rack
mount effects will work better in the FX loop on the amplifer rear. Stomp boxes are normally designed for small signals such
as a guitar output whereas rack mount FX are designed for the higher signal level obtained from an FX send. This socket can
also be used as a Line Level Out.
6 BY-PASS/LEVEL SWITCH: This switch allows the effects loop to be by-passed if not in use, it also gives you the option
of running the FX loop at 0dB (750mV) or at -10dB (250mV) to suit your processor.
EFFECTS LOOP: RETURN: Connect the output from your external effects to this socket. The effects loop allows you to
7
connect external effects such as tremolo's, chorus and delays to your amplifier. All of the signal leaves the amplifier via the
`Send' socket and comes back from the effects via the `Return` socket. Use the output level control on your FX to control
how loud the FX return signal sounds. This is an insert type control, therefore you need to set the Dry/ Wet mix in your FX
processor.
8 FOOTSWITCH SOCKET: Provided for the connection of a Laney FS2 footswitch (optional) .This allows you to remotely
switch between the clean/drive channel and & switch the built in reverb On/Off.
9 INTERNAL CABINET:
cabinet connected ensure that
a speaker connected otherwise you risk damaging the C 0
10 IMPEDANCE SELECTOR SWITCH: This optimises the C 0
the 'on board' speaker set to it 8 ohms. If using an 8-16 ohm extension cabinet at the same time as the onboard speaker, set
the switch to 4 ohms. If you set it wrong it will reduce the life of your output tubes and won't sound as good.
11
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will reduce
the amplifiers performance and in some cases may cause damage to your amplifier. Try the L 5 -112 into a Laney extension
cabinet - you will be amazed what this baby cranks out.
C 0
The internal loudspeaker is connected b
the impedance selector
L 5 -112
y a ¼" (6.3mm)
switch ( ) is set to 8 ohms. In use your C 0 6
's output transformer.
L 5 -112 's output for 4 or 8-16 ohm loads. When using with
jack to this socket. With no extension
L 5 -112 should always have
C 0
Page
13 20