anko SLR-23911 Manual

LIGHT UP WAVY FULL LENGTH MIRROR
IMPORTANT SAFETY INSTRUCTIONS:
The following safety precautions should always be followed, to reduce the risk of electric shock, personal injury or fire. It is
important to read all of these instructions carefully before using the product, and to save them for future reference or new
users.
1. This product must only be used as intended in accordance with the enclosed operating instructions.
2. Do not carry the appliance by the cable or pull the cable to remove the adaptor from the socket.
3. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
4. If the appliance stops unexpectedly or appears to malfunction, unplug the adaptor from the mains and stop using immediately. Seek
professional advice to rectify the fault or make repairs.
5. Switch off the power supply or unplug from the mains socket when not in use, before cleaning or changing accessories.
6. Avoid positioning the appliance where the power cable might be accidentally trapped or damaged.
7. Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.
8. This product has not been designed for use by children.
9. Children should be closely supervised at all times when they are near any electrical appliance.
10. Never reach for any appliance that has fallen into water. Switch off the power supply at the mains immediately and unplug. Do
not re-use until the product has been inspected and approved by a qualified electrician.
11. Always ensure that hands are dry before operating or touching the adaptor.
12. To disconnect, first ensure that all controls are in the OFF position, then remove the adaptor from the electricity supply.
13. Do not use outdoors. This appliance has been designed for domestic indoors use only.
14. The mirror is not replaceable. If the mirror is broken, the whole luminaire shall be discarded.
15. The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
16. A void touching the mirror with sharp objects in order to prevent scratches that might affect the mirror usage.
17. Do not position this light set where it will be exposed to wet condition or submerged in water.
Power adaptor (use provided power adaptor: KL12-2400500AU only)
Input: 100-240V~ 50/60Hz 0.4A
Output: 24V DC 500mA 12W
INSTRUCTIONS FOR USING
1. Insert the DC plug into the socket on the lamp.
2. Check to ensure that all the components have been assembled correctly.
3. Plug in the adaptor to connect to the mains supply.
4. Use remote control to turn on the light. There are multiple modes, colours and functions.
Remote control parameter
2 * 1.5V AAA batteries required (batteries not included)
On / Off
Signal indicator light
Brightness +
Brightness -
MAINTENANCE
1. Before cleaning and maintenance, make sure the power adaptor is unplugged from mains.
2. To clean the lamp, only use a soft, dry or slightly damp cloth (with the addition of some dishwashing
detergent if necessary). Do not use abrasives or solvents for cleaning.
K: 43431489 T: 69735592
SLR-23911
Automatic / Pause
Colour ring (colour selecting)
Mode +
Speed +
Mode -
Speed -