Playing Discs; Playback - JVC FS-Y1A Instructions Manual

Playing discs

Playback

• The power will be turned on when any of PLAY
3, FM, AM, AUX, or 0 on the main unit and
3
, FM, AM, AUX, or 0OPEN/CLOSE
DVD/CD
on the remote control is pressed while the power
is off.
If any button other than 0 or 0OPEN/CLOSE is
pressed, the source will also be changed (if
there is a disc loaded, playback will start).
NOW READING
REGION CODE
ERROR!
NO DISC
OPEN
CLOSE
CANNOT PLAY THIS
DISC
12
(Refer to page 17 for playing MP3/WMA and JPEG.)
page 5
1
Press 0OPEN/CLOSE to open the disc
2
tray to load a disc.
3
Press DVD/CD
The disc tray will close and playback will start.
Screens displayed on the TV when the power is turned ON.
The following messages appear depending on the status of the system.
(When FM, AM or AUX is selected as a source, the messages do not appear.)
Appears when the system is reading the disc information. Wait for a while.
Appears when the Region Code of the DVD VIDEO does not match the code
the system supports. (page 3)
Appears when no disc is loaded.
Appears when opening the disc tray.
Appears when closing the disc tray.
Appears when trying to play back an unplayable disc.
Press AUDIO.
• The power will be turned on and the STANDBY
lamp will go off.
• Press AUDIO again to turn off the power.
3
.
NOTE
• A menu screen may be displayed on the TV after
starting playback of a DVD/VCD/SVCD. In this
case, select a desired item to playback by using the
following buttons on the remote control.
• Select a desired item using cursor
and press ENTER
• Select a desired item using the number buttons.
• Depending on the disc, actual operation may be
different from the description.
Place a disc with the label side
facing up.
•
Place an 8 cm disc in to the
ter.
hollow part in the cen
5 3 ∞
/ /
.
2
/