Floor Stand Setup - Hitachi Director’s UT32X812 Operating Manual

SAFETY PRECAUTIONS (continued)

Floor Stand Setup

1
Remove the Stand Base from the Monitor
Keep the screws. They will
CAUTION
be used for the Floor stand
installation.
Install the Monitor on the Floor Stand
2
For Stand Assembly; please refer to the Installation Manual of the Floor Stand AS-LSZ0081 or AS-LSZ0082.
3
Attach the Monitor to the Floor Stand with the 4 screws used with the
tabletop stand.
Adjust Monitor position left or
CAUTION
right to match with screw holes.
If the screw holes do not align,
the Monitor may be damaged.
Please make sure screws
WARNING
are tightened properly.
UT32X812 LCD UT Monitor is for use with the Hitachi AS-LSZ0081 or AS-LSZ0082 Floor stand
CAUTION
only. Use with other floor stands could cause instability and possible injury.
Remove the 4 screws and raise straight up from tabletop stand.
Monitor
About the Installation
This product is heavy and should be carried
by at least 2 people.
Screws from the
tabletop stand.
12