Adjusting The Projector's Elevator; Using The Security Bar And Slot - Hitachi CP-WX625 User Manual – Operating Manual

RGB
OUT
Y
VIDEO

Adjusting the projector's elevator

When the place to put the projector is slightly uneven to the left or right, use the
elevator feet to place the projector horizontally.
S-VIDEO
R L
Using the feet can also tilt the projector in order to project at AUDIO IN 3
a suitable angle to the screen, elevating the front side of the
projector within 10 degrees.
This projector has 2 elevator feet and 2 elevator knobs. An elevator foot is
adjustable while pulling up the elevator knob on the same side as it.
1.
Holding the projector, pull the elevator knobs up to loose the elevator feet.
2.
Position the front side of the projector to the desired height.
3.
Release the elevator knobs in order to lock the elevator feet.
4.
After making sure that the elevator feet are locked, put the projector down
gently.
5.
If necessary, the elevator feet can be manually twisted to make more precise
adjustments. Hold the projector when twisting the feet.
CAUTION
►Do not handle the elevator knobs without holding the projector,
since the projector may drop down.
►Do not tilt the projector other than elevating its front within 10 degrees using
the adjuster feet. A tilt of the projector exceeding the restriction could cause
malfunction or shortening the lifetime of consumables, or the projector itself.

Using the security bar and slot

A commercial anti-theft chain or wire up to 10 mm in
diameter can be attached to the security bar on the
projector.
Also this product has the security slot for the Kensington
lock.
For details, see the manual of the security tool.
WARNING
►Do not use the security bar and the
security slot to prevent the projector from falling down,
since it is not designed for it.
RGB
NOTE
• The security bar and the security slot are not
OUT
comprehensive theft prevention measures. They are intended Y
VIDEO
to be used as supplemental theft prevention measure.
RGB1
C /P
B B
C /P
R R
AUDIO
R L
OUT
AUDIO IN 4
To loose an elevator foot,
pull up the elevator knob
on the same side as it.
RGB1 RGB2
C /P
B B
C /P
R R
RGB2 M1-D
REMOTE
CONTROL
(3.5Φ)
I O
LAN
M1-D
REMOTE
Setting up
CONTROL
10°
AC IN
To finely adjust, twist
the foot.
Security bar
Anti-theft chain or wire
Security slot
9