DataCard CP60 Printer Manual page 61

Datacard printer owner's manual
Hide thumbs Also See for CP60:
Table of Contents

Advertisement

1 With "Configuration" displayed on line 1, press the Up or Down Arrow key if needed
to display "DHCP/Static IP" on line 2.
2 Press the Enter key. The current address mode value is displayed on line 2.
3 Press the Up or Down Arrow key to display the address mode you want. Possible
values are DHCP and Static IP.
4 Press the Enter key.
5 The next step depends on which address mode you have chosen:
— If you have chosen DHCP, "Apply/Restart" appears on line 2. Press the Enter
key to restart the printer. After the printer restarts, see
Address Mode, IP Addresses, and MAC Address" on page 51
address and other data.
— If you have chosen Static IP, "IP Address" appears on line 2. See
Gateway Address" on page 57
— You must set the IP address, subnet mask, and gateway IP address for the printer. The printer will
restart after you enter these values.
— If you have used the DHCP/Static IP menu selection but did not actually change the address mode, "K
Power" appears on line 2. Press the Up or Down Arrow key to display "Exit" on line 2. Press the Enter key
repeatedly to return to the "Printer Ready" display.
"View the Network
for the steps to follow.
to retrieve the IP
"Set the IP Address, Subnet Mask, and
Page 56

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents