Required Cleaning - Pelpro FPP, IPP Owner's Manual

R
EQUIRED
Proper care of your PELPRO pellet appliance is required for peak, sustained performance. The need for and
frequency of cleaning depends on the amount of pellets burned, pellet quality, length of time since last cleaning
and the quality of the fire. While becoming acquainted with your new stove and the types of local pellets, i nspect
your BURN GRATE, BURN POT, HEAT TUBES, ASH PIT, and WINDOW daily and clean until a pattern of
cleaning requirement is determined . As heating demands increase the need for stove and exhaust system
cleaning and ash removal will increase.
WARNING: Disconnect the electrical cord prior to opening the sides of your stove or opening the exhaust
system for any inspection, cleaning, maintenance or service work. NEVER perform any inspection,
cleaning, maintenance or service on a HOT STOVE or when the electrical cord is plugged in.
EVERY 2 –3 DAYS / WEEKLY
BURN GRATE
[COLD STOVE ONLY] Clean as needed,
scraping off any residue that may stick to
grate bottom or sides.
BURN POT: (B)
[COLD STOVE ONLY] Remove the burn
grate. Clean out the burn pot. CAUTION:
When replacing the grate make sure it fits
properly in the burn pot with the lip on the
burn grate, toward the front of your stove.
HEAT TUBES:
With your stove's main door closed pull the HEAT TUBE SCRAPER ROD forward and backwards a few
times. As different types of pellets produce different amounts of ash, cleaning the tubes enables the heat
exchange to operate efficiently.
CAUTION : On a burning stove the heat tube scraper rod will be hot.
ASH PAN / TRAY (C):
NOTE: Place the ash in a metal container with a tight fitting lid. Place container on a non-combustible
surface well away from all combustible materials. Retain all ash material in container until all cinders have
been thoroughly cooled.
WINDOW CLEANING:
clear view of the fire you should clean your window as needed with a soft cloth or paper towel. You may use
a glass cleaner to remove heavy build up on the window. HOME TIP: Dampen a piece of newsprint with
water, dip this into the fly ash, then rub down the glass. This works like a charm. Do not use abrasive
chemical cleaners. DO NOT OPERATE STOVE WITH BROKEN GLASS AS LEAKAGE OF FLUE GASES
MAY RESULT.
Can
adian Comfort Industries
Copyright 2004
R
: (A)
[COLD STOVE ONLY}
Remove the ashtry, (c), and dump the ash as needed.
[COLD STOVE ONLY as hot glass may cause serious burns] To enjoy a
V04
www.pelprostoves.com
C
OUTINE
Heat Tubes
Tube Scraper
Window
Burn Grate
Burn Pot
E Z Clean
Grate
32
LEANING
PELPRO OWNERS MANUAL
Dansons Group Inc.
Hopper
Auger
Auger Motor
Fan Motors
Exhaust
Air Intake
Ash Pan