How do I run the Drive Assessment Test?
1.
Install and run L&TT
2. Select the device and click Test on the toolbar.
3. In the Test Execution tab, select the drive
4. Select the Drive Assessment test from Test Group.
Leave the options as default.
Use a known good, preferably new, tape that can be
overwritten.
5. Click Start Test. The test will take 10-15 minutes.
6. Open the Test Results tab to see the results of the test.
7. Red stop signs indicate failures. Warnings should be observed but are
not critical.
8. If the test fails with a known, good tape then the drive needs
attention. Contact HP support and
ResultLog.ltt file
send the results in the
.