Troubleshooting - Casio XW-P1 User Manual

Reference
Display
Message
File Name When renaming a file on a memory card, attempting
to specify a file name that is already used.
Invalid Tone You selected a Synthesizer tone, hexlayer tone, or
drawbar organ tone for a part other than PART1
(ZONE1).
Battery Low Battery power is low.
Write Error! Writing to internal storage memory failed.

Troubleshooting

Symptom
Included Accessories
I can't find something that should be
included with the product.
Power Requirements
Power will not turn on.
The display lights up momentarily but
power does not turn on when I press
POWER.
The Synthesizer outputs a loud sound and
then suddenly powers down.
The Synthesizer suddenly powers down
after a few minutes.
Display
The display keeps going out or is flashing. Replace the batteries with new ones or switch over to AC adaptor power (page
Screen contents are visible only from
straight ahead.
Sound
Nothing happens when I press any
keyboard key.
No sound is produced when a start the
Step Sequencer.
Notes keep sounding, without stopping.
Some notes are cut off while they are
playing.
The volume or tone setting I configured
has changed.
Output volume does not change even
though I change my keyboard pressure.
E-82
Cause
Carefully check inside all of the packing materials.
• Check the AC adaptor or make sure that the batteries are facing correctly (page
E-9).
• Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
6
Press POWER firmly and completely to turn on power.
6
Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
This happens when Auto Power Off (page E-10) is triggered.
E-9).
This is due to production limitations. It does not indicate malfunction.
• Adjust the main volume setting (page E-12).
• This Synthesizer does not have built-in speakers. It will no produce unless you
connect some device for sound output (page E-8).
When the arpeggio function is being triggered by start of the Step Sequencer, the
sequence will not start until you play something on the keyboard.
Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
Notes are cut off whenever the number of notes being sounded exceeds the
maximum polyphony value of 64 (1 to 32 for some tones). This does not indicate
malfunction.
• Adjust the main volume setting (page E-12).
• Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
Change the Touch setting (page E-65).
Required Action
Use a different name.
Select Synthesizer, hexlayer, or drawbar organ tones
only for PART1 (ZONE1).
Replace the batteries or change to AC adaptor power
(page E-9).
Try again.
Action