Casio XW-P1 User Manual page 30

Selecting and Creating Tones
■ Block (8): LFO1 and Block (9): LFO2 Editable Parameters
Preparation
Perform the following steps from the screen in step 2 of the procedure under "To edit and save a tone as a user tone" on page
E-21.
1.
Select "LFO >Ent" and then press
2. 9
Use the PART minus (–) and plus (+) buttons to select the block you want to edit.
Editable Parameter List
• (V) at the end of a display item indicates an item that can be selected as a Block (10) virtual controller destination (page E-29).
Display Text
Wave type. Specifies one of the following wave types to be used for LFO.
Sin
(Sine Wave)
Tri
(Triangular Wave)
WaveType
Saw up
(Sawtooth Wave Up)
Saw down
(Sawtooth Wave
Down)
Sync. Specifies what LFO is synced with.
Off: No syncing
Sync
Tempo: Synced with beat specified by clock sync (see below).
LFO1 (Can be selected with LFO2 only.): Synced with LFO1.
Rate. Specifies the LFO speed (frequency). This setting is enabled when the above Sync setting is
Rate (V)
off.
Clock sync. Specifies the number of beats synced with the LFO frequency. Selecting a setting from
Clk.Sync 1/4U to 4U syncs with the timing of the back beat.
• This setting a valid only when the sync setting is "Tempo".
Depth (V) Depth. Specifies how LFO is applied.
Delay (V) Delay. Specifies the degree of delay in the timing for applying LFO.
Rise. Specifies the time it takes from the start of application of the LFO until the effect reaches the
Rise (V)
level specified by Depth above.
Mod.Depth (V) Modulation depth. Specifies how modulation is applied to the LFO.
E-28
bq
ENTER to enter the group.
Description
Puls 1:3
(Square Wave 1:3)
Puls 2:2
(Square Wave 2:2)
Puls 3:1
(Square Wave 3:1)
Random
(Random)
Settings
Refer to the cell to the
left.
Refer to the cell to the
left.
0 to 127
1/4, 1/3, 1/2, 2/3, 1, 3/2,
2, 3, 4, 1/4U, 1/3U, 1/2U,
2/3U, 1U, 3/2U, 2U, 3U,
4U
0 to 127
0 to 127
0 to 127
0 to 127