Nvme Configuration; Onboard Devices Configuration; Apm Configuration - Asus H610T-Em-A Manual

3.3.10 NVMe Configuration
The NVMe Configuration menu displays the NVMe controller and drive information
of the devices connected and allows you to configure NVMe device options
settings.
3.3.11 Onboard Devices Configuration
HD Audio
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the HD Audio Device.
LAN1 I219V
[Enabled] Enables the Intel
[Disabled] Disables the controller.
LAN2 RTL8111H
[Enabled] Enables the Intel
[Disabled] Disables the controller.
M.2 WiFi
Allow you to enable or disable M.2 WiFi function. Configuration options: [Enabled]
[Disabled]
M.2 BT
Allow you to enable or disable M.2 BT function. Configuration options: [Enabled]
[Disabled]
3.3.12 APM Configuration
ErP Ready
Allows you to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss
[S5 State] The system goes into off state after an AC power loss.
[S0 State] The system goes into on state after an AC power loss.
Power On By PCIE
This item allows you to enable or disable the Wake-on-LAN function of the onboard
LAN controller or other installed PCIe/PCI LAN cards. Configuration options:
[Disabled] [Enabled]
Power On By Ring
[Enabled] Enables the Ring devices to generate a wake event.
[Disabled] Disables the Ring devices to generate a wake event.
Chapter 3: BIOS setup
LAN1 controller.
LAN2 controller.
3-9