Operating User Interface Features
30
Setting Preferences, continued
SYSTEM CLEAN
To clean and freshen the washer, perform the
SYSTEM CLEAN cycle. If you wish to begin the
cycle, press select when prompted. The next
screen will instruct you to remove all items from
the wash drum, fi ll the bleach dispenser and press
start. This maintenance cycle uses hot water and
two rinses to remove residue that may cause odor.
See Inside Routine Cleaning (Preventative) for
detailed information about the SYSTEM CLEAN
cycle.
NOTE
The washer will automatically prompt you to run
the SYSTEM CLEAN cycle every 50 cycles. You
may press the button under EXIT to manually
perform the cycle at another time.
RESET
Press the buttons indicated to restore only cycle
settings, reset only factory preferences (users,
language, brightness, volume, etc.) or restore
all factory defaults (both cycle settings and fac-
tory preferences). Press the button under EXIT
to return to normal operation or press the cancel
button to turn the washer off without making any
changes. If you do not make a selection within 30
seconds the washer will return to normal opera-
tion without any changes. If you reset all settings,
INSTALL CYCLE will be displayed as though the
washer were just turned on for the fi rst time. You
may press the button under CANCEL if you do not
wish to rerun the INSTALL CYCLE.
CONTRAST
Press the button beneath plus (+) or minus (-)
symbols to increase or decrease the contrast of
the display. Press select to accept the change or
press the button under EXIT to return to normal
operation without any changes.