Scissor-Jack Overview; Preparing For Installation - Cisco 12016 Instructions Manual

Scissor-Jack Overview

Scissor-Jack Overview
The scissor-jack platform enables a team of two installers to easily move a fully loaded router. This
publication describes how to move a router chassis from an equipment rack and onto the scissor-jack,
and then describes how to move it from the scissor-jack and onto a shipping pallet.

Preparing for Installation

Installation preparation is presented in the following sections:
•
•
•
•
Safety Guidelines
Before you perform any procedure in this publication, review the safety guidelines in this section to
avoid injuring yourself or damaging the equipment. In addition, review the safety warnings listed in the
Regulatory Compliance and Safety Information for the Cisco 12000 Series Internet Router publication
that accompanied your router before installing, configuring, or maintaining the router.
The following guidelines are for your safety and to protect equipment. The guidelines do not include all
hazards. Be alert.
Safety with Equipment
•
•
•
•
•
•
Safety with Electricity
•
•
•
•
•
Cisco 12016, Cisco 12416, and Cisco 12816 Router Scissor-Jack Instructions
2
Safety Guidelines
Preventing Electrostatic Discharge Damage
Required Tools and Equipment
Related Documentation
Always disconnect all power cords and interface cables before moving the system.
Never assume that power is disconnected from a circuit; always check.
Keep tools and assembly components away from walk areas.
Do not work alone if potentially hazardous conditions exist.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
Before beginning any procedures requiring access to the interior of the router, locate the emergency
power-off switch for the room in which you are working.
Disconnect all power and external cables before installing or removing a router.
Never assume that power has been disconnected from a circuit; always check.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Never install equipment that appears damaged.
78-15717-01