Components View; Important Safety Information; Electrical Specifications - Danby Premiere DPAC 11010 Owner's Use And Care Manual

Danby products portable air conditioner owner's use and care guide
Table of Contents

Advertisement

Available languages

Available languages

Air outlet
Signal
receptor
Castor
ELECTRICAL
SPECIFICATIONS
1) All wiring must comply with local and national electrical
codes and be installed by a qualified electrician. If you have
any questions regarding the following instructions, contact a
qualified electrician.
2) Check available power supply and resolve any wiring
problems BEFORE installation and operation of this unit.
3) This appliance draws 10.8 nameplate amps under Cooling
Mode and may be used in any properly wired, general purpose
15 amp household grounded receptacle.
4) For your safety and protection, this unit is grounded
through the power cord plug when plugged into a matching
wall outlet. If you are not sure whether the wall outlets in your
home are properly grounded, please consult a qualified
electrician. DO NOT USE PLUG ADAPTERS OR
EXTENSION CORDS WITH THIS UNIT. If it is necessary to
use an extension cord with this unit, use an approved "air
conditioner" extension cord only (available at most local
hardware stores).
5) The manufacturers nameplate is located on the rear panel of
the unit, and contains electrical and other technical data
specific to this unit.
6) To avoid the possibility of personal injury, always
disconnect the power supply to the unit before installing
and/or servicing.
UNIT PARTS IDENTIFIED
Control Panel
Handle
Hole

IMPORTANT SAFETY INFORMATION

READ ALL SAFETY INFORMATION BEFORE USING
Air intake
(evaporator)
Air intake
hose
Water outlet drain
Suggested Individual Branch Circuit
Nameplate Amps
10.8
AWG- American Wire Gauge
*Based on copper wire at 105°C temperature rating.
Receptacle and Fuse Types
Rated Volts
Amps
Wall Outlet
Fuse Size
Time Delay Fuse
(or Circuit Breaker)
CAUTION: Do not leave this unit
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an enclosed,
unattended space.
3
Air outlet
hose
Power supply cord
TABLE 1
*AWG Wire Size
16
TABLE 2
125
15
15
Plug Type

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents