Remote Control - Philips Dcc 900 Instructions For Use Manual

REMOTE CONTROL
SYSTEM ASPECTS
ys6uq
4a"h ORs
Beanie,
a5 Tes
VOLUME
=a ES
APPEND RECORD
, y
START MARK RECMUTE |
2X1.5V
RO3 / UM4 / AAA
REMOTE CONTROL
— The keys on the remote control have the same functions as
the corresponding ones on the recorder
SEARCH << and »» = BACKWARD << and FORWARD p>.
Extra keys:
0 - 9 digit keys - for selecting track numbers; these keys are
only functional when a DCC cassette (with tracknumber list)
is used.
- VOLUME + - Adjusting the sound level when the recorder
is connected (via the VARIABLE OUT sockets) to an amplifier
or HiFi system;
STANDBY - for selecting standby mode.
IMPORTANT!
When the recorder is incorporated in a HiFi system with ESI |
BUS connection (e.g. Philips 900 series), the IRSENSOR |
ON/OFF switch (F) on the back of the recorder should
always be in the OFF position. The recorder can then be
operated via the remote control of the system.
When the recorder is not incorporated in a HiFi system with |
ESI BUS connection, this switch should be in the ON
position. The recorder can then be operated with the
remote control supplied.
Make sure that the recorder is switched off when the IR
BATTERIES
* Open the battery compartment and insert two batteries as
indicated, type RO3, UM-4 or AAA-ceils.
© Remove the batteries when they have run down or when
they will not be used again for a long period.
16
ENHANCED SYSTEM INTELLIGENCE
If the recorder is connected via the ESI BUS sockets to the
ES! BUS sockets of a HiFi system (e.g. the Philips 900
series), the recorder can be operated via the remote control
of the system. In addition, the functions mentioned below
are then accessible.
NOTE
When using any of the following functions the IR SENSOR
ON/OFF switch on the back of the recorder should be in the
OFF position.
When changing this switch, make sure that the recorder is
switched off.
AUTOMATIC SOURCE SELECTION
lf the AUTO SELECT function on your amplifier is activated,
the recorder will automatically be selected as soon as you
press the PLAY > key.
AUTOMATIC STOP
If the AUTO SELECT function on the amplifier is activated, the
recorder will automatically stop playing or recording as soon as
another source in the system is selected.
e.g. When you select TUNER with the source select knob on
your amplifier while listening to your DCC 900, the recorder
will be stopped.
STANDBY
¢ Switching your recorder to standby can also be done via the
system remote control.
¢ First select DCC on the system remote contro! and then
briefly press the standby key.
— The recorder will be switched to standby.
e If the standby key is kept pressed for more than approx. 1
second the whole system will be switched to standby.
All light indicators will be switched off with the exception of
the standby indicator on the amplifier.
f AUTO SELECT (on the amplifier) is activated, the indicator
of this key will also light up during standby.
NOTE: |f the whole system is switched to stanclby when a
recording is active, the recording will be canceled.
¢ By selecting the DCC source on the amplifier or on the
system remote control the recorder will be activated again.
e The recorder will also be activated again as soon as you
press one of the PLAY», STOP m, NEXT Bi, PREVIOUS I,
FORWARD p> or BACKWARD <«« keys