Page 1
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE! Mit Ihrer inspirierenden Bewertung wird COSTWAY konsistenter sein, um Ihnen EIN SCHÖNES EINKAUFSERLEBNIS, GUTE PRODUKTE und EFFIZIENTEN SERVICE zu bieten! Avec votre évaluation inspirante, COSTWAY continuera à...
Page 6
Step 05 Step 06 Firstly, install the screws on the beam, but do not tighten them. After the uprights are tightened, tighten the screws. If the hole position is not aligned, move the uprights to adjust the position. M6x15 M6x15...
Page 12
Step 15 Note: V is stuck in the position where the small, piece (R1, R2) and the large piece (Q1, Q2) overlap.
Page 13
Step 16 According to the installation order of (Q1, R1) →(Q2, R2) is the best. There is a small hole on the edge of each sheet of iron. This is only a craft hole, not a defect. The small hole is invisible after installation.
Need help?
Do you have a question about the NP10589CF and is the answer not in the manual?
Questions and answers