2. Press the
DNS to set the value. (The selected option is highlighted in blue)
a
b
c
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press
4. If you select Store without pressing the Enter button, the system will
keep the original settings.
R
—
Press
ESET
M
S
—
ENU
ETTINGS
settings consists of the following options:
M
P
ENU
OSITION
the screen.
M
T
ENU
IMEOUT
default, the OSD disappears after 20 seconds of non-activity.
M
T
ENU
RANSPARENCY
background.
M
L
ENU
OCK
menu. Select Off to disable the Menu Lock. If you want to disable the
Menu Lock function and have the OSD disappear, press the Menu button
on the control panel or remote control for 15 seconds, and then disable the
function.
P
ASSWORD
requesting you to enter a password will be displayed when the power plug is
inserted into the electrical output and the power for the projector is first
turned on. By default, this function is disabled. You can enable this feature
by selecting Enabled. If the password has been set before, key in the
52
Using Your Projector
button to enter IP Address, Subnet Mask, Gateway, or
Use
and
buttons to select the option.
Use
and
After the setup is complete, press the
to reset wireless configuration.
Select and press
—
Allows you to change the position of the OSD menu on
—
Allows you to adjust the time for an OSD timeout. By
—
Select to change the transparency level of the OSD
—
Select On to enable the Menu Lock and hide the OSD
—
When Password Protect is enabled, a Password Protect screen
buttons to set the value.
button to store the settings.
to activate the menu settings. The menu
button to exit.