KEY NOT VALID
WRONG PAPER SIZE
PS OPTION ERROR
- IGNORE FLASH
- IGNORE FLASH
Responding to Error Messages
The printer top cover is open.
Close the printer top cover. Press Go to take the printer back on-line.
Printing is in progress.
You will see this message if you try to take the printer off-line by pressing
Go during printing. This message is also displayed when you are
printing one of the internal demonstration or test pages. No action
required. Wait for printing to finish.
This message is displayed when a button that is not enabled in the
current function is pressed.
Press the correct key to complete the current function (see page 11).
The printer is warming up.
Wait until the printer has warmed up and displays READY.
A paper size mismatch has occurred. More than one paper size has
been found in the same tray.
Inspect the trays for mismatched paper and correct.
The parallel port is not communicating with the controller.
Restart the printer. If this error persists, call for service.
An optional ROM DIMM has failed its startup test.
Replace the ROM DIMM.
This message appears when the FORMAT FLASH item is selected
to format the optional Flash ROM. It may also appear when a Flash
ROM with an unsupported format is installed and when the power
is turned on.
Select + (press Value) to format the Flash ROM. Select - (press Shift
and Value) to cancel the operation.
This message appears asking you to confirm that you want to
format the optional Flash ROM if +FORMAT FLASH is selected in
the message above.
Select + (press Value) to begin formatting the Flash ROM. Select -
(press Shift and Value) to cancel the operation.