Problems and Solutions Without
Font not used
Problems and Solutions Without Messages
First page prints correctly in the font and format specified in the
software application, but midway through the job the font and
The printer has initiated a job timeout. When a job timeout occurs, the
downloaded fonts and formatting commands specified by the software
application are lost, so printing after the job timeout is completed without
the downloaded font and format.
If the print job came over the parallel port, increase the I/O TIMEOUT
setting or disable it on the PARALLEL1 MENU or PARALLEL2 MENU
(see pages 71 to 73).
Printer not using the font you want?
You have specified a font that is not available.
Print a PCL or PS Font List and see if the font you specified is available
(see page 90 or 101).
Indicators off and display blank?
Power switch is not turned on.
Check the power switch to ensure the printer is turned on.
Power cord is not attached.
Check the power cord and be sure it is connected at both ends.
No power at the power source.
Check the main power source. Consult an electrician or the local power
company. If you are using a power strip, ensure power lead is connected
at the source and turned on.
One edge of the document is cut off?
You are attempting to print something outside the printable area of the
Use your software application to adjust the margins of the page. Check
and ensure that your software application is not trying to print graphics
or text outside the printable area.