Brother Innov-is 4000DLTD User Manual page 93

Computerized sewing and embroidery machine
Hide thumbs Also See for Innov-is 4000DLTD:
Table of Contents

Advertisement

SEWING THE STITCHES
d
Align the presser foot with the mark on the
fabric, and lower the presser foot.
A
a Mark on the fabric
b Marks on the presser foot
Note
• Pass the thread underneath the presser
foot.
• Slide the outside frame of the buttonhole
foot backward as far as possible as shown in
the illustration, making sure that there is no
gap behind the part of the foot marked "A". If
the buttonhole foot is not slid back as far as
possible, the buttonhole will not be sewn at
the correct size.
e
Lower the buttonhole lever so that it is
positioned behind the metal bracket on the
buttonhole foot.
a
a Buttonhole lever
a Metal bracket
82
a
b
a
f
Gently hold the end of the upper thread,
and then start sewing.
*
Feed the fabric carefully by hand while the
buttonhole is sewn.
→ Once sewing is completed, the machine
automatically sews reinforcement stitches, and then
stops.
Memo
If automatic thread cutting is turned on before
you start sewing, both threads are automati-
cally cut after the reinforcement stitches are
sewn. If the fabric does not feed (for example,
because it is too thick), increase the stitch
length setting.
g
Insert a pin along the inside of one of the
bar tacks, and then insert the seam ripper
into the center of the buttonhole and cut
towards the pin.
a
b
a Basting pin
b Seam ripper
CAUTION
When using the seam ripper to open the
buttonhole, do not put your hand or finger in the
path of the ripper. The ripper may slip and cause
injury.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Innov-ís 4000dltdInnov-ís nv4000dInnov-is 4000d

Table of Contents