Garmin FORCE Field Service Manual page 2

Tools, Supplies, and Equipment Needed for Repair
When performing repair or replacement procedures, you must have the following tools and supplies.
• Suitable workbench or table
◦ Must be at least 8 ft. long for working on the 50 in. models
◦ Must be at least 10 ft. long for working on the 57 in. models
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• 3 mm and 4 mm and 8 mm hex bits or wrenches
• 10 and 15 mm socket
• 29 mm socket or wrench (for replacing the PCB)
9
• / in. socket
16
◦ For removing the propeller
◦ A 15 mm socket is acceptable, if necessary
• 36 mm or adjustable wrench (for replacing the coil cable)
• Torque wrench
◦ With 4 mm, 6 mm, and 8 mm hex bits
◦ Capable of measuring torque from 5 kgf-cm (4.3 lbf-in) to 55 N-m (40.5 lbf-in.)
• Silicone lubricating grease (for replacing the latching mechanism or steering servo components)
• Needle-nose pliers
• Dielectric grease (for replacing the power cable or coil cable)
• Shaft and motor hardware service kit
◦ S00-01000-35
◦ For replacing the shaft or propeller drive motor
• Metal parts accessory kit
◦ S00-01000-20
◦ Contains all of the metal parts, such as brackets and screws, that may be needed when performing repairs
• Plastic parts accessory kit
◦ S00-01000-46
◦ Contains all of the plastic parts, such as washers and bushings, that may be needed when performing
repairs
2