Liquid Crystal Display (Lcd); Lcd Message; Printer Status Messages - Brother HL-8050N User Manual

Liquid Crystal Display (LCD)

The display shows the current printer status. When you use the control panel buttons, the display will
change.
If you take the printer off-line, the display changes to show the emulation you have chosen.
If there are any problems, the display shows the appropriate error message, maintenance message or
call service message so you will know that you need to take action. For more information about these
messages, see What to Do When an Error Message Appears on page 5-15.

LCD Message

Printer status messages

The following table shows the printer status messages that are displayed during normal operation:
Messages
READY
PRINTING
RESOLUTION ADAPT
PROCESSING
JOB CANCELLING
PAUSE
WARMING UP
SLEEP
PRESS SET TO PRINT
RESET TO FACTORY
SETTING
SELF TEST
RAM SIZE=XX MB
NOW INITIALIZING
PROGRAMING-WAIT
IGNORE DATA
DATA EXISTS (*)
COOLING DOWN
* Data that is being created exists, and no data is being received. Pressing the Go button performs
FORM FEED and changes the display message to PRINTING.
4 - 9 CONTROL PANEL
Ready to print.
Printing.
Printing with reduced resolution.
Busy processing data.
Cancelling the job.
The printer has suspended its functions. Pressing the Go button starts the printer
again.
The printer is warming up.
In Sleep state
Press the Set button to start printing.
The printer setting returns to the factory settings.
Performing self-diagnostics.
This printer has XX MB memory.
The printer is setting up.
Accessing CompactFlash card.
PS data is being read and disregarded.
Incomplete data exists.
Wait for a few seconds until inside of the printer has cooled down.
Meaning