Using Arp To Configure The Ip Address - Brother MFC-255CW Network Manual

Appendix A

Using ARP to configure the IP address

If you are unable to use the BRAdmin application and your network does not use a DHCP server, you can
also use the ARP command. The ARP command is available on Windows
installed as well as UNIX
arp -s ipaddress ethernetaddress
Where ethernetaddress is the Ethernet address (MAC address) of the print server and ipaddress is the
IP address of the print server. For example:
®
Windows
®
Windows systems require the dash "-" character between each digit of the MAC Address (Ethernet
Address).
arp -s 192.168.1.2 00-80-77-31-01-07
® ®
UNIX /Linux
®
Typically, UNIX and Linux
Address (Ethernet Address).
arp -s 192.168.1.2 00:80:77:31:01:07
Note
You must be on the same Ethernet segment (that is, there cannot be a router between the print server and
operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP
address.If your Administrator has configured the system to deliver IP addresses using BOOTP, DHCP or
RARP your Brother print server can receive an IP address from any one of these IP address allocation
systems. In which case, you will not need to use the ARP command. The ARP command only works once.
For security reasons, once you have successfully configured the IP address of a Brother print server using
the ARP command, you cannot use the ARP command again to change the address. The print server will
ignore any attempts to do this. If you wish to change the IP address again, use TELNET (using the SET
IP ADDRESS command) or factory reset the print server (which will then allow you to use the ARP
command again).
To configure the print server and to verify the connection, enter the following command ping ipaddress
where ipaddress is the IP address of the print server. For example, ping 192.189.207.2.
®
systems. To use arp enter the following command at the command prompt:
®
systems require the colon ":" character between each digit of the MAC
®
systems that have TCP/IP
A
A
140