Charge The Scanner; Led Indicators - Honeywell COB02 Installation Manual

Charge the Scanner

Ensure all components are dry prior to mating
batteries with peripheral devices. Mating wet
components may cause damage not covered by the
warranty.
1. Place a scanner into the cradle to charge.
2. When a scanner is inserted, the green LED flashes
according to the chart below. If the green LED does not
appear, check to make sure the scanner is seated
completely in the charger with the battery contacts
touching the contacts on the charger.
3. When the battery is completely charged, the green charging
indicator stops flashing and stays illuminated.

LED Indicators

LED Status
Red
On
Green
Off
Slow flash
On
Fast flash
Indicates
Power is on
Battery not detected
Pre-charge and charge
Charge completed
Charge suspended due to a fault condition
6