Advertisement
Quick Links
Visit portable receiver
Buttons and controls
Power LED
Volume
Flash LEDs
Test button
Technical specifications
In the box
BE1450 Portable receiver
4
1.5V LR14 batteries
Wall bracket
Screws and wall plugs
Power and battery
Mains power
7.5 V DC / 1500 mA
Optional power supply unit
Battery power: 4
1.5 V LR14
alkaline batteries
Operating time: 2 – 3 years with
alkaline batteries
Power consumption: Active: 1000 mA
Idle position: 0.1 mA
Environment
Operating temperature:
0° to 35° C, 32° to 95° F
Relative humidity: 15% to 90%,
non condensing
Visit LEDs
Recesses for wall bracket
Dimensions and weight
Height: 165 mm, 6.5"
Width: 130 mm, 5.1"
Depth: 36 mm, 1.5"
Weight: 590 g, 20.8 oz. incl. batteries
Visit LEDs
The Visit LEDs normally indicate
the following:
Orange LED, pacifier symbol
The baby monitor is activated
Green LED, door symbol
The door transmitter is activated
Yellow LED, telephone symbol
The phone transmitter is activated
Red LED, fire symbol
The smoke alarm is activated
Orange and red LEDs blink alternately
The CO alarm is activated
Flash signal switch
Battery compartment
Output
Adjustable sound signal
Max 93 dBA @ 1 m, frequency
range: 500 – 1000 Hz
Bed shaker outlet: 2.0 – 4.0 VDC
Frequency and coverage
Frequency: 433.92 MHz or 868.3
MHz, depending on region
Coverage by region:
433 MHz: 30 – 80 m (98 - 260 ft)
868 MHz: 50 – 250 m (55 - 273 yd)
Coverage depends on the radio
frequency, building's characteristics
and the combination of transmitters
and receivers.
Accessories
BE1270 Bed shaker
Bellman & Symfon power supply
unit for Europe or UK
BE1450
BE1270 Bed shaker
Optional power supply
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Bellman & Symfon BE1450
Summary of Contents for Bellman & Symfon BE1450
- Page 1 Recesses for wall bracket Battery compartment Optional power supply Technical specifications In the box Dimensions and weight Output BE1450 Portable receiver Height: 165 mm, 6.5" Adjustable sound signal Max 93 dBA @ 1 m, frequency 1.5V LR14 batteries Width: 130 mm, 5.1"...
- Page 2 Visit portable receiver Getting started Slide open the battery cover, fit the batteries and close the cover again. Place the receiver on a level surface or mount it on the wall using the wall bracket. To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter. The receiver lights up a Visit LED and starts to flash and sound.
- Page 3 Visit portable receiver Changing the radio key If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio interference, you need to change the radio key on all units. The radio key switches are located on the transmitters. Here is how you change the radio key: Open the transmitter cover and move any radio key switch to the up (on position) to change the radio key.
- Page 4 Visit portable receiver Advanced programming By using advanced programming, you can customize the signal pattern from a specific transmitter and event, displaying the LED color, sound and vibration pattern of your choice. The advanced programming overrides the radio key and pairs the units via the serial number.
Need help?
Do you have a question about the BE1450 and is the answer not in the manual?
Questions and answers