Beyond Lighting KOOT ADJUSTABLE Series Installation Instruction

KOOT ADJUSTABLE SERIES
INSTALLATION INSTRUCTION
INSTALLATION MANUAL
1
Open the hole for the fixture to be mounted. After preparing the
drainage, fill the hole with gravel up to 20-30 cm considering a
provision for power cable. To check the drainage, pour a bucket of
water into the open pit and make sure that the water is drained
within 15-20 minutes. Take attention with the position level being
careful to place a suitable drainage bed.
4
Adjust the fixture's direction as your requirement using allen key.
IP67
Upon request
1 - 10V
PHYSICAL
Body
Frame
Recessing tube
OPTICAL
Diffuser
Light Emission
Aiming
CRI
ELECTRICAL
CCT
Driver
Ambient Temp.
Ambient Humidity
2
Place the recessed box in the hole.
5 YRS
7 - 100
IK10
WATTS
Warranty
220-240V
DALI DMX RGB
Aluminum Alloy
Stainless Steel 316L
Aluminum Alloy
Tempered Glass
Adjustable
Fixed
>80
3000K - 4000K (RGB available on request)
Electronic included | 50-60Hz
220-240VAC Non-Dimmable Driver
1-10V dimming or DALI on request
-25°C ~ 50°C
10% ~ 90%
3
Connect the main power cable to the cable of the luminaire with
the use of an IP68 connector or special insulation material.
Install the lamp body of LED inground light and fix the recessing
box and lamp body by screws.
BEYOND LIGHTING FACTORY •