Download Print this page

After Use; Inspection And Repairs; Safety Of Others - Black & Decker HSMC1321 Instruction Manual

Hide thumbs Also See for HSMC1321:

Advertisement

Available languages

Available languages

ENGLiSh
to test an isolated area of the surface to be cleaned before
proceeding. We also recommend that you check the use and
care instructions from the floor manufacturer.
• Never put de‑scaling, aromatic, alcoholic or detergent
products into the steam cleaner, as this may damage it or
make it unsafe for use.
• If the circuit breaker activates while using the steam
function, discontinue product use immediately and
contact the customer support center. (Beware of the risk of
electrical shock.)
• The appliance emits very hot steam to clean the area of use.
This means that the steam floor head and cleaning pads get
very hot during use.
• Always wear suitable shoes when using your steam cleaner
and when changing the accessories on your steam cleaner. Do
not wear slippers or open‑toed footwear.
• Steam may escape from the appliance during use.
• Care should be taken when using this appliance. DO NOT
touch any parts which may become hot during use.

AFTER USE

• Unplug the appliance and allow to cool.
• When not in use, the appliance should be stored in a
dry place.
• Children should not have access to stored appliances.

INSPECTION AND REPAIRS

• Unplug the appliance and allow to cool down before
performing any maintenance or repairs.
• Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches and
any other conditions that may affect its operation.
• Regularly check the power cord for damage.
• Do not use the appliance if any part is damaged or defective.
• Have any damaged or defective parts repaired or replaced
by an authorized repair agent.
• Never attempt to remove or replace any parts other than
those specified in this manual.

SAFETY OF OTHERS

• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
Residual Risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use, etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
• Injuries caused by touching any moving parts.
• Injuries caused by touching any hot parts.
• Injuries caused when changing any parts or accessories.
• Injuries caused by prolonged use of the appliance. When
using any appliance for prolonged periods ensure you take
regular breaks.
8
ASSEMBLY
NOTICE: Each steam mop is 100% tested in the factory to
ensure product performance and safety. When assembling
your new steam mop for the first time, you may notice water
residue inside of the unit.

WARNING: Before attempting any of the following
operations, make sure that the appliance is switched off
and unplugged and that the appliance is cold and contains
minimal or no water.
Attaching the Handle (Fig. B)
 8 
• With both cord hooks 
 6 
end of the handle tube 
 10 
mop body 
until it is firmly seated and clicks into place.
Attaching the Handheld Steam Cleaner (Fig. C)
• Push the handheld steam cleaner 
 10 
mop body 
until it clicks into place.
Removing the HandHeld Steam Cleaner (Fig. D)
• Push the release button 
 2 
steam cleaner 
away from the steam mop body 
Attaching a Cleaning Pad (Fig. A, E)
Replacement cleaning pads are available from your
BLACK+DECKER dealer (cat. no. SMP20).
• Place a microfiber cleaning pad 
'hook & loop' side facing up.
• Press steam mop down onto the cleaning pad. You are
now ready to steam clean your floor.
NOTICE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle
 6 
tube 
in the upright position when stationary and make
sure the steam mop is turned off and unplugged when not
in use.
Removing a Cleaning Pad (Fig. E)

CAUTION: Always wear suitable shoes when changing
the cleaning pad on your steam mop. Do not wear slippers or
open‑toed footwear.
1. Return the handle tube 
turn the steam mop 'OFF'.
2. Wait until it cools down (approximately five minutes).
3. Place the front of your shoe onto the cleaning pad
 29 
removal tab 
and press down firmly.
4. Lift the steam mop up off the cleaning pad.
NOTICE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle
 6 
tube 
in the upright position when stationary and make
sure the steam mop is turned off and unplugged when not
in use.
Handheld Steam Cleaner Attachments
NOTICE: Remove the handheld steam cleaner from the steam
body after turning off and unplugging the steam mop, and
after allowing the steam mop to cool down.
Attaching the Hose and Steam Glove (Fig. F)
1. Firmly press the hose (
of the handheld steam cleaner so it is fully seated.
2. To remove, depress the hose release button 
the hose out of the handheld steam cleaner.

WARNING: Inspect the seal 
 2 
 32 
cleaner 
and the seal 
facing the back, slide the bottom
into the top end of the steam
 2 
firmly into the steam
 9 
down and pull the handheld
 10 
 21 
on the floor with the
 6 
to the upright position and
 11 
 14 
or 
) onto the steam nozzle
 30 
 31 
on the handheld steam
at the end of the hose before each
.
, and pull

Advertisement

loading
Need help?

Need help?

Do you have a question about the HSMC1321 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Hsmc1361Hsmc1361sgpkHsmc1361sgpHsmc1321apb