Timeout Between Decodes - Motorola Symbol LS2208 Product Reference Manual

Timeout Between Decodes

Timeout Between Decodes, Same Symbol
This parameter sets the minimum time between decodes of the same symbol. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. Setting this above 0.4 seconds is recommended. The default for this
parameter is 0.6 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes beginning in
Codes on page D-1
example, to set a timeout of 0.5 seconds, scan the bar code below, then scan the "0" and "5" bar codes. If an error
occurs, or to change the selection, scan Cancel on page D-3.
Timeout Between Decodes, Different Symbol
This parameter sets the minimum time between decodes of different symbols. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. The default for this parameter is 0.2 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes beginning in
Codes on page D-1
example, to set a timeout of 0.5 seconds, scan the bar code below, then scan the "0" and "5" bar codes. If an error
occurs, or to change the selection, scan Cancel on page D-3.
that correspond to the desired timeout. Include a leading zero for single digit numbers. For
Timeout Between Same Symbol
that correspond to the desired timeout. Include a leading zero for single digit numbers. For
Timeout Between Different Symbol
User Preferences 4 - 9
Numeric Bar
Numeric Bar