Assa Abloy Norton Rixson CloserPlus CLP7570 Series Installation Instructions

CLP7570/CLP7770 or CPS7570/CPS7770 Series
®
CloserPlus Security Door Closer
Non Hold Open or Hold Open
Parallel Arm Installation Instructions
WARNING
This product can expose you to lead which is known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65warnings.ca.gov.
Note: For Special Applications a separate door and frame preparation template is packed with these instructions.
Use this instruction sheet for installation sequence and closer adjustments only.
Series
Sized*
Closer
CLP7770
* CLP7770 Series are sized door closers with 50% power increase capability.
Power size 2 weakest power, power size 6 strongest.
** CLP7570 Series can be adjusted from power size 1 thru 6.
*For closers with or without "DA" suffix Delayed Action closing feature
**Note:
Arm Stop
Right Hand Door – RH
Left Hand Reverse – LHR
Ÿ
Door closer cover is handed and cannot be reversed. All other components are non handed.
Ÿ
It is recommended that the door, on which the door closer will be installed, be hung on ball bearing hinges or offset pivots. Door must
swing freely.
Ÿ
A separate door stop, supplied by others, is recommended to prevent damage to the door closer, closer arm, or to the door, frame or
adjacent walls.
Ÿ
Door and Frame must be properly reinforced, or use of special fasteners employed, to prevent the mounting screws from pulling out.
Ÿ
All dimensions are given in inches with corresponding metric dimensions (mm) in parenthesis.
Ÿ
Torx tamper resistant drive machine screws are normally supplied with this product.
Copyright © 2002, 2014, 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9377-0625-020 Rev 3 03/22
For closers with or without "T" suffix Hold Open Control
"T" indicates Thumbturn actuated hold open control.
Multi-Sized **
Closer
Security Door Closer
CLP7570
(Door Closer with both a Security Cover and Security Arm)
The closing force for series 7500 door closer is adjustable from a size 1 to a size 6, as outlined
in ANSI Standard A156.4. When this series of door closer is installed and adjusted to conform to
ADA reduced opening force requirements (5 lbs max.) for interior doors, it may not have adequate
closing force to reliably close and latch the door. Power adjustments charted on pages 3,4 and 5
are recommended where possible, to ensure proper door control.
Push Side Installation
Closer mounts on opposite to hinge (push) side of door.
Product Type
Right Hand Reverse – RHR
NORTON
RIXSON
An incorrectly installed or improperly
adjusted door closer can cause
property damage or personal injury.
These instructions should be
followed to avoid the possibility of
misapplication or misadjustment.
Arm Stop
Left Hand Door – LH