11.9 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
11.10 Frost precautions
If the appliance is installed in an area
where the temperature can reach values
around 0° C or drop below, remove the
remaining water from the inlet hose and
the drain pump.
12. CONSUMPTION VALUES
Stated values are obtained in laboratory conditions with relevant stand‐
ards. Different causes can change the data: the quantity and type of
laundry and ambient temperature. Water pressure, the supply voltage
and the temperature of inlet water may also affect the washing pro‐
gramme duration.
Technical specifications may be changed without prior notice to improve
the quality of product.
Programmes
Cottons
60°C
Cottons
40°C
Synthetics
40°C
Delicates
40°C
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
Load
Energy
(kg)
con‐
sumption
(kWh)
7
1,44
7
0,98
3
0,54
2
0,50
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
Water
Approxi‐
con‐
mate pro‐
sumption
gramme
(litre)
duration
(minutes)
84
205
85
215
50
140
49
75
ENGLISH
27
Remain‐
ing mois‐
1)
ture (%)
53
53
35
35
Need help?
Do you have a question about the PerfectCare 800 EW8T3732PF and is the answer not in the manual?