Sony DRN-XM01C Operating Instructions
Operating instructions
Hide thumbs
Also See for DRN-XM01C:
- Specifications (2 pages) ,
- Installation manual (2 pages) ,
- Service manual (54 pages)
Advertisement
Quick Links
3-234-494-11(1)
Digital Audio
Receiver
Operating Instructions
Before operating the unit, install the unit correctly by referring
to the Installation Guide.
You need to subscribe for XM™ Satellite Radio Service to listen
to the radio broadcast.
OWNER’S RECORD
The model number is located on the bottom and serial number
also on the bottom. Record the serial number in the space
provide below. Refer to these numbers whenever you call upon
your Sony dealer regarding this product.
Model No.
Serial No.
Radio ID
DRN-XM01C
DRN-XM01R
DRN-XM01H
Printed on 100%
recycled paper using
VOC (Volatile Organic
Sony Corporation © 2001 Printed in Japan
Compound)-free
vegetable oil based ink.
WARNING
To prevent fire or shock hazard, do not expose the unit
to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
INFORMATION
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution
• Do not operate the unit in a way that might divert your attention from
driving safely. As a driver, you alone are responsible for safely
operating your vehicle in accordance with traffic safety laws at all times.
• Do not install the unit where it may obstruct your view through the
windshield or your view of your vehicle’s indicator displays.
• Do not install the unit where it may hinder the function of safety
devices such as an air-bag. Doing so may prevent the air-bag from
functioning properly in the event of an accident.
• The installation and use suggestions contained in this manual are
subject to any restrictions or limitations that may be imposed by
applicable law— purchaser should check applicable law for any
restrictions or limitations before installing and/or operating this
product.
• Failure to follow these safety instructions and warnings may result in a
serious accident.
Before You Begin
Thank you for choosing the Sony digital audio receiver!
It will give you many hours of reliable service and listening pleasure.
Before operating the receiver, please read these instructions thoroughly
and retain them for future reference.
If you have any questions about the product, you may call:
Sony Direct Response Center 1-(800)-222-7669 or write to:
Sony Direct Response Center 12451 Gateway Blvd. Fort Myers, FL 33913
Declaration of Conformity
Trade Name:
SONY
Model:
DRN-XM01
Responsible Party: Sony Electronics Inc.
Address:
680 Kinderkamack Road, Oradell, NJ 07649 USA
Telephone Number: 201-930-6972
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If you have any questions or problem concerning this product, consult
your nearest Sony dealer: 1-(866)-473-7669.
If you have any questions or problem concerning the XM Satellite
radio service including the broadcast, consult XM.
The Radio ID is required when consulting XM. It is located on the
bottom of the main unit, and you can also check it in the display of
this unit (see “Displaying the Radio ID”).
Introducing XM™ Satellite
Radio
There’s a world beyond AM and FM. XM Satellite Radio. Up to 100
channels. Coast-to-Coast Coverage. Digital quality sound. With many
commercial-free music channels. Plus, the best sports, comedy, talk, news
and entertainment, including USA Today, Discovery Radio, NASCAR,
Sesame Workshop, CNNfn and CNN/SI. Questions? Visit
www.xmradio.com. The future is waiting.
How to Subscribe
Listeners can subscribe by visiting XM on the Web at www.xmradio.com
or by calling XM’s Listener Care at (800)852-9696. Customers should have
their Radio ID ready; it is located on the bottom of the main unit, and you
can also check it in the display of this unit (see “Displaying the Radio
ID”).
Technology. It is prohibited to copy, decompile, disassemble, reverse
engineer or manipulate any technology incorporated in receivers
compatible with the XM Satellite Radio system. Furthermore, the AMBE
®
voice compression software included in this product is protected by
intellectual property rights including patent rights, copyrights, and trade
secrets of Digital Voice Systems, Inc. The user of this or any other
software contained in an XM Radio is explicitly prohibited from
attempting to copy, decompile, reverse engineer, or disassemble the
object code, or in any other way convert the object code into human-
readable form. The software is licensed solely for use within this product.
Features
• This unit is exclusively for the XM Satellite radio.
• Display function for a variety of text information about the tuned-in
channel.
• Memo function enables the unit to store the text information for up to
10 memories.
• Preset function for up to 5 channels.
• Transportable type receiver, which can be attached and removed from
the cradle easily.
• Jog roller and remote commander for easy operation.
• Category Scroll function using a specified category for easy channel
selection.
• Auto Power Down function enables the unit to automatically turn
power off.
Precautions
For customers who use this unit in a car
• When you turn off the ignition switch of your car, be sure to turn off the
power of the unit by pressing the POWER button on the main unit or
remote commander. Otherwise the unit may drain car battery.
• When you get out of your car, remove the main unit from the cradle and
take it with you to prevent it from being stolen.
Troubleshooting
Should any problem persist after you have made the following checks,
consult your nearest Sony dealer. Consult XM if you have any questions
or problem concerning the broadcast service of the XM Satellite radio.
The unit cannot receive channels at all.
• When “CHECK ANTENNA” appears in the display
The supplied antenna is not connected to this unit. Check the
connection of the antenna cord, then turn the power on again.
• When “NO SIGNAL” appears in the display
The receiving condition is not good. Move to the place where the
condition is good.
The unit cannot receive a particular channel.
• You need to subscribe for XM.
• When “UPDATING” appears in the display
You have not subscribed for XM or the channel is not authorized. You
need to subscribe for XM.
• When “OFF AIR” appears in the display
The channel is not broadcasted now.
• When “
CH---” appears in the display
XM
The channel to be tuned-in is void due to the change by the broadcast
service, or the receiving condition is not good.
You cannot select a desired channel.
• In Category Scroll mode, you can select only the channels that
correspond to the Channel Category you selected in the menu. Select a
different Channel Category or change to the Channel Scroll mode. See
“Using the Category Scrolls”.
“SYSTEM ERROR” appears in the display and you cannot operate the
unit.
• A system error occurs. Consult the Sony Direct Response Center.
“--------” is displayed for the text information about Artist Name/
Feature, Song/Program Title, Additional Information, or time
information.
• There is no text information or time information in the channel. This is
not an error.
• The text information may not be displayed depending on the unit
condition, for example, right after the unit has received a channel.
When selecting a channel, or if “LOADING” appears in the display
while selecting a channel, JOG roller, X ⁄ x and preset buttons may
not work.
• You cannot select a channel until the unit finishes receiving the entire
audio data or text information.
The unit automatically turns power off.
• The Auto Power Down is functioning. This turns off the unit
automatically when no operation is performed for the specified time. To
change the setting, see “Using Other Functions”.
Sound distortion occurs.
• When using the unit with the cassette adaptor, sound distortion may
occur. Adjust the Line Out Level. See “Using Other Functions”.
The sound is low.
• Adjust the Line Out Level to the maximum level. See “Using Other
Functions”.
Display is dim, or no indication is displayed.
• The unit is being used in extremely high or low temperatures or in a
place with excessive moisture.
The remote commander does not function.
• Remove any obstacles between the remote commander and the unit.
• Use the remote commander near the unit.
• Point the remote commander at the remote sensor
on the unit.
• Replace battery in the remote commander with new one if it is weak.
Icon List
The following icons appear in the display.
indicates the Channel Number
XM
indicates the Channel Name
CHAN
indicates the Artist Name/Feature
NAME
indicates the Song/Program Title
TITLE
indicates the Additional Information
INFO
indicates time and date
TIME
indicates the Category
CAT
indicates the Menu display
MENU
Specifications
Main unit
Time display
12-hour system
Auto power down function
OFF/60 min/120 min/180 min
Output
LINE OUT jack (ø 3.5 mm stereo minijack)
Power requirements
6 V DC, DC IN 6V jack
Dimensions
Incl. projecting parts and controls:
Main unit:
Approx. 105 × 40 × 120 mm (w/h/d)
× 1
× 4
1
5
3
(Approx. 4
/
/
/
inches)
4
8
4
When the main unit is installed in the car cradle with the car stand:
Approx. 105 × 68 × 128 mm (w/h/d)
× 2
× 5
1
3
1
(Approx. 4
/
/
/
inches)
4
4
8
When the main unit is installed in the home cradle with the home
stand:
Approx. 105 × 55 × 128 mm (w/h/d)
× 2
× 5
1
1
1
(Approx. 4
/
/
/
inches)
4
4
8
Not incl. projecting parts and controls:
Main unit:
Approx. 102 × 38 × 120 mm (w/h/d)
× 1
× 4
1
1
3
(Approx. 4
/
/
/
inches)
8
2
4
When the main unit is installed in the car cradle with the car stand:
Approx. 102 × 66 × 128 mm (w/h/d)
× 2
× 5
1
5
1
(Approx. 4
/
/
/
inches)
8
8
8
When the main unit is installed in the home cradle with the home
stand:
Approx. 102 × 53 × 128 mm (w/h/d)
× 2
× 5
1
1
1
(Approx. 4
/
/
/
inches)
8
8
8
Mass
Main unit:
Approx. 220 g (7.8 oz)
When the main unit is installed in the car cradle with the car stand:
Approx. 380 g (13.4 oz)
When the main unit is installed in the home cradle with the home
stand:
Approx. 300 g (10.6 oz)
Remote commander
Power requirements
3V DC, one CR2025 lithium battery
Dimensions
Approx. 52 × 89 × 12 mm (w/h/d)
× 3
×
1
5
1
(Approx. 2
/
/
/
inches)
8
8
2
incl. projecting parts and controls
Mass
Approx. 30 g (1.1 oz) incl. lithium battery
Design and specifications are subject to change without notice.
Installing the Main Unit in the
Cradle
Insert the main unit completely into the cradle until the main unit is
locked in the cradle.
Cradle
Cradle release
button
Main unit
Cradle release
button
To remove the main unit from the cradle
While pressing the two cradle release buttons on the left and right sides of
the main unit, pull out the main unit from the cradle.
Replacing the Lithium Battery
into the Remote Commander
Replace the battery when the buttons on the remote commander do not
work. Remove the old battery and insert a new one.
2
1
3
1
Insert a long and thin object into the hole, then pull out the
lithium battery holder.
2
Replace the lithium battery with the positive (+) side facing
up.
3
Insert the battery holder into the remote commander until it
clicks.
Battery life
(Approx.)
Sony lithium battery CR2025
1 year
Notes on lithium battery
• Keep the lithium battery out of reach of children. Should the battery be
swallowed, immediately consult a doctor.
• Wipe the battery with a dry cloth to assure good contact.
• Be sure to install the battery in the correct polarity position.
• Do not hold the battery with metallic tweezers, as doing so may cause a
short-circuit.
• Do not break up the battery or throw it into a fire, which might cause it
to explode.
• Carefully dispose of the used battery.
Note
When the unit is not to be used for a long period of time, remove the
battery to avoid damage from battery leakage and corrosion.
Advertisement
Related Manuals for Sony DRN-XM01C
Summary of Contents for Sony DRN-XM01C
- Page 1 Mass • When you turn off the ignition switch of your car, be sure to turn off the automatically when no operation is performed for the specified time. To power of the unit by pressing the POWER button on the main unit or...
- Page 2 Press DSPL/BACK (or DSPL on the remote). Turn JOG roller (or press X ⁄ x on the remote) to select If the current UTC data is not received, “– – : – –” appears in the display. Memo “Storing the Information”...